Filter
Top Products
button will give a maximum of +16% or (+100%
for CD) pitch
.
15. RELOOP BUTTON - If a SEAMLESS LOOP
has been made (see setting a SEAMLESS LOOP
on page 19), but the CD Player is not actively in
SEAMLESS LOOP mode (a loop is not playing),
pressing the RELOOP BUTTON will instantly
reactivate the SEAMLESS LOOP mode. To exit
loop, press the OUT BUTTON (16)
. LOOP and
RELOOP will appear in the VFD DISPLAY (2)
when the RELOOP function is available.
16. OUT BUTTON - This button is used to set
the ending point of a loop. A loop is started by
pressing the IN BUTTON (17),
pressing the OUT
BUTTON set the loop ending point. The loop
will continue to play until the OUT BUTTON
is
pressed once again.
17. IN BUTTON - “CUE ON THE FLY” - This
function allows you to set a CUE POINT (see CUE
POINT page 17) without music interruption (“on
the fly”). This button also sets the starting point
of a seamless loop (see SEAMLESS LOOP).
18. PLAY/PAUSE BUTTON - Each press of the
PLAY/PAUSE BUTTON causes the operation to
change from play to pause or from pause to play.
While in play mode the blue play L.E.D. will glow,
and while in pause mode the blue play L.E.D. will
flash.
19. CUE - Pressing the CUE button during play-
back immediately pauses playback and returns
the track to the last set cue point (see setting a
CUE POINT, page 17). The green CUE L.E.D. will
glow when the unit is in cue mode The L.E.D. will
also flash every time a new CUE POINT is set.
The CUE button can be held down to momen
-
tarily play the CD. When you release the CUE
button it instantly returns to the CUE POINT. You
can also tap the CUE button to create a BOP
EFFECT (for definition of BOP EFFECT, see page
25).
20. RELAY BUTTON - This button activates the
FLIP-FLOP™ function.
21. EJECT FUNCTION - Pressing this will eject
the CD. The eject function will only when the unit
GENERAL FUNCTIONS AND CONTROLS (Cont.)
is in cue mode, this is to prevent accidentally
ejecting the disc when in play mode.
B. REMOTE CONTROL - REAR
22. REMOTE JACK - Connect the supplied 8 pin
din cable from this jack to the player's remote
connector. This will allow you to control the func
-
tions of the player .
23. CHANNEL 1 CONTROLLER JACK - Connect
the supplied mini-plug from the CUE jack on the
rear of your CD unit to the CONTROL out jack of
a compatible American Audio
® or American DJ®
mixer. This will enable the CD "Q-Start" function.
This feature is only available on American Audio
®
“Q” series mixers.
24. CHANNEL 2 CONTROLLER JACK - Connect
the supplied mini-plug from the CUE jack on the
rear of your CD unit to the CONTROL out jack of
a compatible American Audio
® or American DJ®
mixer. This will enable the CD "Q-Start" function.
This feature is only available on American Audio
®
or American DJ
® “Q” series mixers.
©American Audio® - www.americanaudio.us - MCD-710™ Instruction Manual Page 11