Filter
Top Products
Troubleshooting
Symptom Possible Problem Solution
No power. One or both power cords are not connected or the main
or rear surround units have not been turned on.
Plug the PT8051’s AC cords into a suitable AC outlet.Then, turn on the PT8051
by pushing the on/off switch in the rear of the unit for both the main and rear
surround units.
Power switch on the back panel is not turned on for one
or both units.
Turn it on.
A safety mechanism powered down the PT8051. Unplug the PT8051 from the AC outlet briefly and then plug it in again so it will
reset itself.
No sound
comes from
the PT8051.
The volume is set too low. The “+/–” buttons on the top of the PT8051 remote are the master volume controls.
Press and hold the “+”button to increase the volume.
Loose or no cable connections on the PT8051 or source
equipment.
Check that the cables are correctly and firmly seated on both the PT8051 and the
source equipment.
MUTE is on. Be sure mute function is not activated.
No on-screen
display.
Video cable is loose or not connected. Check that the video cable is connected and properly seated at both the PT8051
VIDEO OUTPUT and the TV input.
The wrong input is selected on the TV. Select the correct input on the TV, the one that corresponds to where the VIDEO
OUT cable from the PT8051 is connected.
No sound is
coming from the
rear surround unit.
Power switch on the back panel is not turned on for one
or both units.
Turn it on.
There is no surround information on the DVD soundtrack. It is normal not to have surround sound information present at all times.
The REAR +/– level is set too low.
Increase the REAR +/– level by using the remote control.
The rear surround unit has lost synchronization with the
main unit.This is indicated by a blinking green WIRELESS
light on the rear surround unit.
Make sure that the front and rear units are within 40 feet (12.2 meters) of each
other.To manually resynchronize the main and rear surround units press the
CONNECT button on the rear of the front unit. Once synchronization has occurred
the WIRELESS light on the rear surround unit will stop blinking and remain lit in a
steady on state.
Specifications
Power Supply Rating
120 VAC/60 Hz
Power Consumption 25W (Main Unit) 20W (Rear Surround Unit)
Signal-to-Noise Ratio (A-weighted
) >75dB
Dimensions (W x H x D) 40" x 6
3
⁄4" x 6" (1016mm x 170mm x 152mm)
22" x 6
3
⁄4" x 6" (560mm x 170mm x 152mm) (Rear Surround Unit)
Weight 18.1 lbs. (8.2 kg) (Main Unit)
9.8 lbs. (4.4 kg.) (Rear Surround Unit)
Output Power 125 Watts (5 x 25) Continuous Average Power
Drivers Three NXT Digital 2" x 8" (50mm x 200mm) Flat Panel Drivers (Main Unit)
2.3" x 4" (58mm x 100mm) (Rear Surround Unit)
Digital Audio Inputs Two Optical/One Coaxial
Analo
g Audio Inputs
S
tereo x 3
Analo
g Audio Outputs
Subwoo
fer x 1
Video Output Composite x 1
F
r
equenc
y r
esponse
70 Hz
–
20 kHz +/
–
3dB
Wireless Transmission Frequency 2.4 GHz
Wireless Transmission Range (Maximum) 40 Feet (12.2 Meters)
Specifications are subject to change without notice. Trademark of New Transducers Limited.
12