Filter
Top Products
23-EN
Lock pin
3 Slide the CDM-7892R into the dashboard. When the
unit is in place, make sure the locking pins are fully
seated in the down position. This can be done by
pressing firmly in on the unit while pushing the locking
pin down with a small screwdriver. This ensures that the
unit is properly locked and will not accidentally come out
from the dashboard. Install the Detachable Front Panel.
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the “up” position (see Fig. 3). As each
pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second
pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Front frame
Dashboard
Installation
1
Remove the Detachable Front Panel (refer to page 4).
Slide mounting sleeve from main unit (see Removal
Procedure below). Slide the mounting sleeve into the
dashboard.
2
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the CDM-7892R and put
the Rubber Cap on the hex bolt. If your vehicle does
not have the Mounting Support, reinforce the head unit
with the metal mounting strap (not supplied). Connect
all the leads of the CDM-7892R according to details
described in the CONNECTIONS section.
NOTE
For the screw ∗, provide a proper screw to the chassis installing
location.
Rubber Cap
(Included)
Bracket
Mounting sleeve
(Included)
CDM-7892R
Hex Bolt
(Included)
Screws (M5 × 8)
(Included)
CDM-7892R
Mounting Bracket
∗
Metal Mounting Strap
Screw
Bolt Stud
Hex Nut (M5)
CDM-7892R