Filter
Top Products
17-EN
Adjusting Source Signal Levels
If the difference in volume level between the CD player
and FM radio is too great, adjust the FM signal level as
follows.
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the g DN or f UP button to select the FM-
LV (FM LEVEL) mode.
3 Press the BAND button to select the FM signal level HI
(High) or LO (Low) to make the signal levels between
the FM band and CD player closer.
4 Press the SETUP button to return to normal mode.
Switching the Tuner Mode
The CDM-7892R incorporates the MAX TUNE Pro for
the highest quality tuner audio. Moreover, you can
choose between 3 settings to suit your own personal
sound preferences usage.
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the g DN or f UP button to select
NORMAL.
3 Press the BAND button to switch the TUNER mode.
NORMAL : Standard setting
STABLE : Noiseless priority setting
HI-FI : Sound quality priority setting
NOTES
• The initial setting at the factory is "NORMAL."
• If you find the sound is very noisy while listening to the
tuner in the HI-FI mode, we recommend you change to the
NORMAL mode.
SETUP Operation
BAND
f UP
g DN
SETUP
4 When the setting is completed, press the SETUP
button to return to the normal mode.
Subwoofer On and Off
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the g DN or f UP button to select the
SUB-W mode.
3 Press the BAND button to select Subwoofer ON or
OFF.
4 Press the SETUP button after setting the SUB-W ON.
5 Press the MODE button repeatedly to select the
SUB-W mode.
Press the g DN or f UP button after selecting the
SUB-W mode, and the subwoofer output phase is
toggled SUBW NOR (0°) or SUBW REV (180°).
6 Turn the Rotary encoder until the desired sound is
obtained in each mode.
NOTES
• Initial mode is "Subwoofer ON."
• Set to "Subwoofer OFF" unless the subwoofer is used.
Setting Frequency Step
When you tune in FM stations automatically, you can
set the frequency step to 50 kHz or 100 kHz.
1 Press and hold the SETUP button for at least 3
seconds to enter the setting mode.
2 Press the g DN or f UP button to select the
frequency step mode.
3 Press the BAND button to select the desired frequency
step (50 kHz or 100 kHz). Each time you press the
BAND button, 50 kHz and 100 kHz appear alternately.
50 kHz: the unit tunes in FM stations every 50 kHz
automatically.
100 kHz: the unit tunes in FM stations every 100 kHz
automatically.
4 Press the SETUP button to exit the setting mode.
Rotary encoder/MODE
→ NORMAL → STABLE → HI-FI
→ SUB-W → BALANCE
VOLUME ← DEFEAT ← FADER ←