Filter
Top Products
4-EN
Never Attempt the Following
Do not grip or pull out the disc while it is being
pulled back into the player by the automatic
reloading mechanism.
Do not attempt to insert a disc into the unit
when the unit power is off.
Inserting Discs
Your player accepts only one disc at a time for
playback.
Do not attempt to load more than one disc.
Make sure the label side is facing up when you
insert the disc. Your player will automatically
eject any disc that is inserted incorrectly. If the
player continues to eject a correctly inserted
disc, push the Reset switch with a pointed
object such as a ball-point pen.
Playing a disc while driving on a very bumpy
road may result in skips, but this will not
scratch the disc or damage the player.
New Discs
As a protective measure to prevent the CD
from jamming, the CD player will automati-
cally eject discs with irregular surfaces or
inserted incorrectly. When a new disc is
inserted into the player and ejected after initial
loading, using your finger, feel around the
inside of the centre hole and outside edge of
the disc. If you feel any small bumps or
irregularities, this could inhibit proper loading
of the disc. To remove the bumps, rub the
inside edge of the hole and outside edge of the
disc with a ball-point pen or other such
instrument, then insert the disc again.
Irregular Shaped Discs
Be sure to use round shape discs only for this
unit and never use any special shape discs.
Use of special shape discs may cause damage
to the mechanism.
Center Hole
Bumps
Outside
(Bumps)
Center Hole
New Disc