Filter
Top Products
ALPINE PDR-V75 68-25285Z56-A (EN/FR/ES)
8-EN
SWI
NOTE:
• Before
the po
w
perpe
n
Cros
s
CONNECTION CHECK LIST
Please check your head unit for the conditions
listed below: (Fig. 9)
Remote Turn-On Lead
a. The head unit does not have a remote turn-on
or power antenna lead.
b. The head unit’s power antenna lead is activated
only when the radio is on (turns off in the tape
or CD Mode).
c. The head unit’s power antenna lead is logic level
output (+) 5V, negative trigger (grounding type),
or cannot sustain (+) 12V when connected to
other equipment in addition to the vehicle’s
power antenna.
If any of the above conditions exist, the remote
turn-on lead of your PDR-V75 must be
connected to a switched power source (ignition)
in the vehicle. Be sure to use a 3A fuse as close
as possible to this ignition tap. Using this
connection method, the PDR-V75 will turn on
and stay on as long as the ignition switch is on.
If this is objectionable, a SPST (Single Pole,
Single Throw) switch, in addition to the 3A fuse
mentioned above, may be installed in-line on
the PDR-V75 turn-on lead. This switch will then
be used to turn on (and off) the PDR-V75.
Therefore, the switch should be mounted so that
is accessible by the driver. Make sure the switch
is turned off when the vehicle is not running.
Otherwise, the amplifier will remain on and
drain the battery.
Blue/White
Power Antenna
Remote Turn-On Lead
To other Alpine component’s Remote Turn-On
Leads
SPST Switch (optional)
Fuse (3A)
As close as possible to the vehicle’s ignition tap
Ignition Source
PDR-V75
Fig. 9