Filter
Top Products
8 Patch Release Note
Patch 86253-07 for Software Release 2.5.3
C613-10382-00 REV E
When two devices are BSR candidates, and have the same preference set
with the SET PIM BSRCANDIDATE PREFERENCE command, the device
with the higher IP address was not elected as the candidate. This issue has
been resolved.
A Prune message sent to an old RP neighbour was ignored when a new
unicast route was learned. This issue has been resolved.
On Rapier series switches, an Assert message was not sent after the prune
limit expired. This issue has been resolved.
The log message “
IGMP Snooping is active, L3FILT is activated”
has been changed to “
IGMP packet trapping is active, L3FILT is
activated
”. The revised message is clearer when IGMP is enabled and
IGMP snooping is disabled.
The following changes have been made to the ADD FIREWALL POLICY
RULE and SET FIREWALL POLICY RULE commands:
• An IP address range for the IP parameter is now only accepted when
enhanced NAT is configured.
• An IP address range for GBLREMOTE parameter is now only accepted
when reverse or reverse-enhanced NAT is configured.
• The GBLIP parameter is not accepted for a public interface when
enhanced NAT is configured.
When the interval between the NTP server and client exceeded 34 years 9
days and 10 hours, the time set on the client was incorrect. This issue has
been resolved.
MVR was not operating if IGMP had not been enabled. This issue has been
resolved.
A fatal error occurred when the PURGE STP command was executed when
STP instances were defined with VLAN members. This issue has been
resolved.
PCR: 31040 Module: PIM Level: 2
PCR: 31041 Module: PIM Level: 3
PCR: 31042 Module: PIM Level: 3
PCR: 31044 Module: SWI Level: 4
PCR: 31052 Module: FIREWALL Level: 3
PCR: 31058 Module: NTP Level: 3
PCR: 31063 Module: IPG Level: 2
PCR: 31068 Module: STP Level: 2