Filter
Top Products
Patch 86253-07 For Rapier Series Switches SHOW IGMPSNOOPING ROUTERADDRESS 15
Patch 86253-07 for Software Release 2.5.3
C613-10382-00 REV E
When static port security was enabled with the RELEARN parameter in the
SET SWITCH PORT command, and a switch port was reset or unplugged,
the MAC entries were removed (unlearned) from the forwarding database
table. The MAC entries should only be removed when dynamic port
security is in use. This issue has been resolved.
When executing the command:
ADD IP ROUTEMAP ENTRY SET ASPATH
followed by the command:
ADD IP ROUTEMAP ENTRY COMMUNITY ADD=YES
where the values for ROUTEMAP and ENTRY were the same in both
commands, the second command failed and returned a “
ROUTEMAP clause
already exists
” error message. This issue has been resolved.
Features in 86253-04
Patch file details are listed in Table 3:
Patch 86253-04 includes all issues resolved and enhancements released in
previous patches for Software Release 2.5.3, and the following enhancements:
MLD snooping is now supported on AT-9800 Series Switches and Rapier i
Series Switches. For details, see “MLD Snooping” on page 30.
The ability to log MAC addresses whenever the ARP cache changes has
been added. To enable this, use the command:
ENABLE IP ARP LOG
To disable it, use the command:
DISABLE IP ARP LOG
The logging of MAC addresses is disabled by default. Use the SHOW LOG
command to view the MAC addresses that have been logged when the ARP
cache changes.
The performance of IPv6 has been improved by introducing IPv6 flows.
PCR: 31190 Module: SWI, SW56 Level: 2
PCR: 31194 Module: BGP, IP Level: 3
Table 3: Patch file details for Patch 86253-04.
Base Software Release File
86s-253.rez
Patch Release Date
17-October-2003
Compressed Patch File Name
86253-03.paz
Compressed Patch File Size
585295 bytes
PCR: 02414 Module: IPV6, SWI, IPG, VLAN
PCR: 02577 Module: IPG, LOG Level: 4
PCR: 03162 Module: IPV6 Level: 3