Filter
Top Products
Patch 86253-07 For Rapier Series Switches DISABLE IP IGMP ALLGROUP 33
Patch 86253-07 for Software Release 2.5.3
C613-10382-00 REV E
New Commands
This enhancement request introduces two new commands from enabling/
disabling all-group entries on switch ports.
ENABLE IP IGMP ALLGROUP
Syntax ENABLE IP IGMP ALLGROUP=[{port-list|ALL}]
where:
■ port-list is a port number, a range of port numbers (specified as n-m), or a
comma separated list of port numbers and/or ranges. Port numbers start
at 1 ad end at m, where m is the highest numbered Ethernet switch port,
including uplink ports.
Description This command enables the specified port(s) to behave as a multicast all-group
ports.
The ALLGROUP parameter specifies the list of ports able to behave as all-
group entry ports. If ALL is specified, all ports are able to behave as all-group
entry ports. The default is ALL.
Examples To enable ports 1, 5 and 7 to behave as all-group entry ports, use the command:
ENABLE IP IGMP ALLGROUP=1,5,7
See Also DISABLE IP IGMP ALLGROUP
SHOW IP IGMP
DISABLE IP IGMP ALLGROUP
Syntax DISABLE IP IGMP ALLGROUP=[{port-list|ALL}]
where:
■ port-list is a port number, a range of port numbers (specified as n-m), or a
comma separated list of port numbers and/or ranges. Port numbers start
at 1 and end at m, where m is the highest numbered Ethernet switch port,
including uplink ports.
Description This command disables the specified port(s) from acting as a multicast all-
group entry ports. Ports that are disabled have a “#” symbol next to the port
number in the output of the SHOW IP IGMP command.
Examples To prevent ports 1, 5 and 7 from behaving as all-group entry ports, use the
command:
DISABLE IP IGMP ALLGROUP=1,5,7
See Also ENABLE IP IGMP ALLGROUP
SHOW IP IGMP