Filter
Top Products
Patch 86253-07 For Rapier Series Switches SHOW IGMPSNOOPING ROUTERADDRESS 29
Patch 86253-07 for Software Release 2.5.3
C613-10382-00 REV E
If ALL is specified, all configurable ICMP message replies are disabled. If
NETUNREACH is specified, all network unreachable message replies are
disabled (RFC792 Type 3 Code 0). If HOSTUNREACH is specified, all host
unreachable message replies are disabled (RFC792 Type 3 Code 1). If
REDIRECT is specified, all ICMP redirect message replies are disabled (RFC792
Type 5 Code 0, 1, 2, 3).
Example To disable all configurable ICMP messages, use the command:
DISABLE IP ICMPREPLY=ALL
See Also ENABLE IP ICMPREPLY
DISABLE IP ECHOREPLY
SHOW IP ICMPREPLY
ENABLE IP ICMPREPLY
Syntax ENABLE IP
ICMPREPLY[={ALL|NETUNREACH|HOSTUNREACH|REDIRECT}]
Description This command enables ICMP reply messages.
If ALL is specified, all configurable ICMP message replies are enabled. If
NETUNREACH is specified, all network unreachable message replies are
enabled (RFC792 Type 3 Code 0). If HOSTUNREACH is specified, all host
unreachable message replies are enabled (RFC792 Type 3 Code 1). If
REDIRECT is specified, all ICMP redirect message replies are enabled (RFC792
Type 5 Code 0, 1, 2, 3).
Example To enable all configurable ICMP messages, use the command:
ENABLE IP ICMPREPLY=ALL
See Also ENABLE IP ECHOREPLY
DISABLE IP ICMPREPLY
SHOW IP ICMPREPLY
SHOW IP ICMPREPLY
Syntax SHOW IP ICMPREPLY
Description This command display the status of configurable ICMP messages (Figure
Figure 2: Example output from the SHOW IP ICMPREPLY command:
SHOW IP ICMP REPLY MESSAGES
--------------------------------------------------------------------------------
ICMP REPLY MESSAGES:
Network Unreachable ................ disabled
Host Unreachable ................... disabled
Redirect ........................... enabled
--------------------------------------------------------------------------------