Filter
Top Products
MANUAL TUNING
1
2
BANDI
MODE
TUNER
SHIFT
Press the TUNER button repeatedly to select the
desired band.
m
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
\AJhen using the remote control, press the BAND/MODE
“WNER button repeatedly while power is on.
Press the q< or ➤> button to select a station.
Each time the button is pressed the frequency changes.
\Nhen a station is received,
“TUNE’r is displayed for 2 seconds.
During FM stereo reception, “STEREO” is displayed.
When an FM stereo broadcast contains Inoise
Press the BAND/MODE TUNER button while pressing the SHIFT
button on the remote control.
“MONO” appears on the display.
Noise is reduced, although reception is monaural.
m
To restore stereo reception, press the buttons again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER button
during power on.
TO reset the interval, repeat this procedure,
Bm
● When the AM tuning interval is changed, all preset stations
(see “PRESETTING STATIONS”) are cleared. The preset
!stations have to be set again.
To search for a station quickly (Auto Search)
Keep the +< or ➤F button pressed until the tuner starts
searching for a station, After tuning in to a station, the search
Stolps,
To stop the Auto Search manually, press the <<or ›~ button.
* The Auto Search may not stop at stations with very weak
signals.
7 ENGLISh!