Filter
Top Products
To stand the AM antenna on a surface
Fix the claw to the slot,
~
To position the antennas
FM feeder antenna:
Extend this antenna horizontally in a T-shape and fix its ends to
the wall.
AM loop antenna:
Position to find the best direction.
m
● Do not connect any speakers to the unit other than the supplied
ones.
● Do not leave objects generating magnetism near the speakers.
● Do not bring the FM antenna near metal objects or curtain rails,
● Do not bring the AM antenna near other optional equipment,
the stereo system itself, the AC cord or speaker cords, since
noise will be picked up.
● Do not unwind the AM antenna wire.
CONNECTING AN OUTDOOR ANTENNA
For better FM reception, use of an outdoor antenna is
recommended.
Colnnect the outdoor antenna to the FM 75 Q terminals.
I To connect other optional equipment+ page 17. I
REMOTE CONTROL
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size
AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as well.
m
● The ➤ button on the remote control has the same function as
that of the <b button on the main unit,
● If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage,
● The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor on the left top of the front panel (see the illustration of
“BEFORE OPERATION”) is exposed to intense light, such
❑
as direct sunlight
- Other remote controls are used nearby (television, etc.)
SHIFT
FUNCTION
(D
To use the SHIFT button
Buttons (!) have two different functions, One of the functions is
indicated on the button, and the other on the plate above the
button,
To use the function on the button, simply press the button,
To use the function on the plate above the button, press the
button while pressing the SHIFT button.
To use the FUNCTION button
The FUNCTION button substitutes for the function buttons
(TAPE, TUNER, AUX, CD) on the main unit. Each time the
FUNCTION button is pressed while power is on, the next function
is selected cyclically,
ENGLISH 4