Filter
Top Products
BEFORE OPERATION SETTING THE CLOCK
To turn the unit on
Press one of the function buttons (TAPE, TUNER, AUX, CD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
The POWER button is also available.
After use
Press the POWER button to turn off the power. The display
changes to the clock,
Ueing the headphones
Cc,nnect the headphones to the PHONES jack with a stereo mini
plug (rz3.5 mm, ‘/8 inch).
Nc, sound is output from the speakers while the headphones are
plugged in.
1,3,5
2,4
■
E-=-=2+5=-=4
CLOCK
SHI[:T
When the AC cord or the car battery cord is connected for the
first time, the time on the display flashes.
Set the time as follows while the power is off.
1
2
3
4
5
Press the 11 button.
The hour flashes.
Press the +-4 or ➤F button to designate
hour.
Press the II button to set the hour.
the
The hour stops flashing and the minute starts flashing.
Press the +-4 or W button to designate the
minute.
Press the II button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 second.
To correct the current time
Press the POWER button to turn the unit off. Press the 1I button,
the clock display flashes and carry out steps 1 to 5 above,
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The time is displayed for 4 seconds.
However, the time cannot be displayed during recorcling.
To switch to the 24-hour standard
Press the CLOCK button while pressing the SHIFT button on
the remote control and then press the
■ button within 4 seccmds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 12 hours, all
settings stored in memory after purchase need to be reset.
5 ENGLISH