Filter
Top Products
POSITIONING THE SPEAKERS (NSX-A34
only)
Position the speakers to make the most of the SURROUND effect.
Standard positioning
0 Fronl speaker (Right)
@ Fronl speaker (Left)
@l Surrcwnd speakers
Place the surround speakers behind the listening area.
To mount the surround speakers on the wall
Mount each speaker on a s~ot that can hold its weiaht.
e
*.
,“’:, ,.. ..
~,
4
$-’
m
Sound is not heard from the surround speakers when the
SURROUND is set to off,
COINNECTING AN OUTDOOR ANTENNA
For better FM reception, use of an outdoor antenna is
recommended.
Connec: the outdoor antenna to the FM 75 Q terminals.
~nnect other optiorwd equipment + page 21.
REMOTE CONTROL
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries. ‘
R6iAA)
When to replace the batteries
The”maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones,
To use the SHIFT button on the remote control
Buttons @ have two different functions, One of these functions
is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the
button while pressing the SHIFT button.
To use the FUNCTION button on the remote control
The FUNCTION button substitutes for the function buttons (TAPE/
DECK 1/2, TUNER, VIDEO/AUX,CD) on the main unit.
Each time the FUNCTION button is pressed, the next function is
selected cyclically. When tapes are inserted in both decks, both
decks are selected with the FUNCTION button.
,C.JCJU
@
cl=
SHIFT
:1*
Qm
+Flb
FUNCTION
PRESET
;3--””
____...’
u
The + ➤/> PRESET button on the remote control
The function is same as that of the > PRESET button on the
main unit.
● If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
● The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
ENGLISH6