Filter
Top Products
1
2
4*
DIR/
PRESET
1
2
SHIFT
BANDI
MODE
TUNER
Press TUNER/BAND repeatedly to select the
desired band.
m
When TUNEFUBAND is pressed while the power is off, the
previously tuned station will be played (Direct Play Function).
To select a band with the remote control
Press BANDIMODE TUNER repeatedly.
Press 4+ DOWN or W UP to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE is displayed for 2 seconds.
During FM stereo reception, “[IIUDII]” is displayed.
When an FM stereo broadcast contains noise
Press BAND/MODE TUNER while pressing SHIFT on the remote
control so that “MONO appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press these buttons so that “MONO
disappears.
MONO
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing +~ DIFUPRESET during power
on.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
To search for a station quickly (Auto Search)
Keep + DOWN or - UP pressed until the frequency starts
to change rapidly. After tuning into a station, the search stops.
To stop the Auto Search manually, press + DOWN or - UP.
● The Auto Search may not stop at stations with very weak
signals.
7 ENGLISH