Filter
Top Products
6
3,7
SHIFT
8
2
4,5
In the programmed edit recording function, the track can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
m
The programmed edit recording will not starl from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
Use the remote control from step 2 to 8.
1
2
3
4
Insert the tape into deck.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press FUNCTION repeatedly until “CD” is
displayed and load the disc.
Press EDIT/CHECK twice while pressing SHIFT
button.
“EDIT” lights up and “PRGM” flashes on the display.
PRGM
EDIT
Press numbered buttons O-9to designate the tape
length.
10 to 99 minutes can be specified.
Examp/e: When using a 60-minute tape, press 6 and O.
● The + and > are also available to designate the tape
length.
Maximum recording
Tape length
time for side A
5
Tape side A
(front side)
Press the numbered buttons O-9 and +10 to
program a track.
Examp/e To select the 10th track, press +1Oand O.
Repeat step 5 for the rest of the tracks ‘for side A. d$
}
,j ?,,,
A track whose playing time is longer than the remaining time {~ ~,
cannot be programmed.
,*J+
&
,~”.
&:.
:,:* w,,
Selected Program
tracks number
1
I
7 Press EDIT/CHECK while pressing SHIFT to
select side B and program the tracks for side B.
After confirming “B on the display, repeat step 5.
Tape side B (reverse side)
8 Press ● TAPE REC/REC MUTE and then press
- within 2 seconds to start recording,,
The tape is rewound to the beginning of the front side, the
lead segment isplayed through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press
■. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press EDIWCHECK while pressing SHIFT to
select side A or B, and press < or - repeatedly.
Program Programmed
Track number number track numbers
Tape side
To change the program of each side
Press EDiT/CHECK while pressing SHIFT to select side A or B,
and press W CLEAR to clear the program on the selected side.
Then program tracks again.
To clear the edit program
Press W CLEAR twice so that “EDIT” disappears on the display.
Recording is inhibited if the erasure prevention tab on either side
of the tape is broken off.
ENGLKH 14