Filter
Top Products
This section explains how to record from the tuner, CD player, or
external equipment.
3
2
II
:
1
lY=---
-=====+1
Preparation
● Use Type I (normal) tapes only.
● Set the tape to the point where recording will start.
1
2
3
4
●
TAPE REC/
REC MUTE
Insert the tape to be recorded on into deck.
Insert the tape with the side to be recorded on first facing out
from the unit and the exposed side down.
Press TAPE/REV MODE to select the reverse
mode.
To record on one side only, select Z.
To record on both sides, select =) or C=).
Press function (TUNER, AUWVIDEO or CD) and
prepare the source to be recorded.
To record from a CD, press CD and load the disc.
To record from a radio broadcast, press TUNEFUBAND and
tune in to a station.
To record from aconnected source, press AUXP.IIDEO and
play.
Press ● REC/REC MUTE to start recording.
When the selected function is CD, playback and re;ording
start simultaneously.
m
To stop recording, press ■ .
To pause recording, press [l (applicable when the source is
TUNER or AUWVIDEO). To resume recording, press it again.
To start recording with the remote control
First press
● TAPE REC/REC MUTE, and then press > within
2 seconds.
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting the recording.
Insertion of 4-second blank spaces may help you to locate the
beginning of the track on other equipments. This unit can add
blank spaces only when the source is TUNER or ALDVWDEO.
1 Press .REC/REC MUTE during recording or while in
recording pause mode.
~ on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press II to resume recording.
To insert a blank space of less than 4 seconds, press
●REC/REC MUTE again while ~ is flashing.
To insert blank spaces of more than 4 seconds, after the deck
enters the recording pause mode, press
●REC/REC MUTE
again.
Each time
●REC/REC MUTE is pressed, a 4-second blank
space is added.
‘This unit does not have the function to locate the beginning of track.
m
Recording cannot be done when TAPE function is selected.
To erase a recording
Make sure the microphone is not connected to this unit.
1 Insert the tape to be erased into the deck.
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing TAPE/REV MODE.
4 Press AU)UVIDEO and turn the connected equipment off.
5 Press . REC/REC MUTE to start the erasure.
ENGLISH 12