Filter
Top Products
SETTING THE TIMER
1
2,4
3
1,2
6
The unit can be turned on at a specified time every day
built-in timer.
Preparation
Make sure the clock is set correctly,(See page 5.)
Use the remote control.
1
2
3
4
with
the
Press the TIMER button on the remote control
once to display 0, and press the II SET button
within 4 seconds.
~
is displayed, and the hour flashes.
Ifyou do not press the 11SET button within 4 seconds, another
operation may start.
Designate the hour of the timer-on time by
pressing the l<< DOWN or F>l UP button, and
the II SET button. Repeat to designate the minute
of the timer-on time.
After you designate the timer-on time, TIMER and one of the
source name flashes alternately on the display for 4 seconds.
Within 4 seconds, press one of the function
buttons to select a source.
“TIMER” and the selected source name flash alternately for 4
seconds. At this time, the selected function button does not
light up.
● If this step is not completed within 4 seconds, repeat from
step 1.
● If the TUNER button is pressed, the band cannot be selected
in this step.
Within 4 seconds, select the duration for the
timer-activated period with the
l<< DOWN or ➤>1
UP button.
5
6
The duration for the timer-activated period can be set between
10 and 240 minutes in 10-minute steps.
● If this step is not completed within 4 seconds, repeat from
step 1.
Prepare the source.
To listen to a CD, load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
Press the POWER button to turn the unit off after
adjusting the volume and tone.
@
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
To check the specified time and source
Press the TIMER button on the remote control. The timer-on
time and the selected source name are displayed for 4 seconds.
However, the duration for the timer-activated period will not be
displayed.
TIMER RECORDING
Timer recording is applicable for TUNER and VI DEO/AUX (with
an external timer) sources only.
Press the TIMER button twice on the remote control so that
.~ appears on the display, and press the 11SET button within
4 seconds.
Repeat the steps shown above from step 2 and
insert the tape to be recorded into deck 2 after step 5.
To cancel timer standby mode temporarily
Press the TIMER button on the remote control so that @ or Q
disappears on the display.
To restore the timer standby mode, press again to display @ or
m
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the
power, repeat step 5 to prepare the source,
and adjust the volume and tone.
● Timer playback and timer recording will not begin unless the
power is turned off.
● Connected equipment cannot be turned on and off by the built-
in timer of this unit.
Use an external timer.
19 ENGL/S/-/