Filter
Top Products
SELECTION OF AUDIO/VIDEO
SOURCE
1
2
3
FUNCTION
Function indicators
ENTER
DOWN;UP
I MU~Tl JOG
VIDEO 1/5.1CH/BAND
Select the program source.
Turn the FUNCTION selector or press the TAPE MONITOR
button. The selected function indicator flashes in red.
I TaDe I TAPE MONITOR
I
I Radio
I TUNER
I
Record
PHONO
Compact disc
CD
Television, etc.
AUX
Video
VIDEO l/DVD/MD,
VIDEO 2/LD/TV, VIDEO 3
I LD or Cable TV I VIDEO 2
I
I MD or DVD
I VIDEO l/DVD/MD
I
To select a function on the remote control
Press the desired function button directly.
The function to be selected (except PHONO) depends on the
equipment connected to the input terminals on the rear panel
of the unit.
When using a turntable with a built-in equalizer amplifier, set
the switch of the equalizer amplifier to off. Seethe instructions
of the turntable for further information.
Start the selected program source.
Adjust the sound.
About the video source to the monitor or TV
To select the video source
1 Trun the FUNCTION to select PHONO, CD or AUX.
2 Press the ENTER button to display VIDEO 1.
3 Turn the MULTI JOG to select VIDEO 2 or VIDEO 3.
To change a displayed name for the VIDEO
1 and VIDEO 2
When the VIDEO 1 is selected, VIDEO 1 is displayed initially. It
can be changed to DVD or MD.
Press the VIDEO l/5.1 CH/BAND button while pressing the
ENTER button.
To use the 5.1CH function, press the VIDEO l/5.1 CH/BAND
button. The function name will change to “5.1 ch IN” and the
source connected to the 5.1 INPUT terminals is selected.
To resume, press the button again so that the selected function
name is displayed.
The displayed name for VIDEO 2 button can be changed to
VIDEO 2, LD orTM while the VIDEO 2 function is selected, press
the VIDEO 1/5.1 CH/BAND button while pressing the ENTER
button.
To adjust the sound level of the connected
source
The input sensitivity level of each function (except the TUNER
function) can be adjusted.
When the sound level of the connected source is higher or lower
than that of the TUNER, adjust it as follows.
1 Select the function to be adjusted.
Turn the MULTI JOG accordingly and play the source.
2
Press the UP or DOWN button repeatedly.
The level can be adjusted between -6dB (MIN) and +8dB (MAX)
in 2dB steps. Adjust the level so that the sound is output at the
same level as the TUNER.
● The input sensitivity level of the TUNER function cannot be
adjusted.
● That of the TAPE MONITOR cannot be adjusted either.
Even if the TAPE MONITOR is selected and the TAPE
MONITOR indicator turns red, pressing the UP or DOWN button
will change the level of the function displayed on the window.
Selected video source
V1: VIDEOI ,V2: VIDE02, V3: VIDE03
The selected video source is indicated on the display and the
video signal through the MONITOR VIDEO OUT jack is output
on the TV.
1 I ENGLISH