Filter
Top Products
5,1CH INPUT jack of this unit support the DOLBY DIGITAL
SURROUND system.
Connect a DVD player with 5.1 ch output jacks to this unit using
cables with RCA phono plugs as follows;
DVD player’s jack
This unit’s jack
5.1CH OUTPUTFRONT(L, R), etc. 5,1CH INPUT FRONT(L, R)
5,1CHOLITPUTSURROUND(L,R),etc. 5.ICH INPUT REAR(L, R)
5.1CHOIJTPUTCENTER,etc.
5.1CH INPUTCENTER
5.ICH OIJTPUTSUB WOOFER,etc. 5.1CH INPUTSUB WOOFER
LINE OUT(L, R), etc.
VIDEO/AUX/PHONOIN (L, R)
——————— /
● If the [)VD player is not connected to VIDEO/AUX/PHONO IN
jacks:
- the spectrum analyzer does not show the sound level of the
DVD player.
- the sound from the connected DVD player cannot be recorded.
To remove these limitations, connect the LINE OUT jacks of
the DVD player to VIDEO/AUX/PHONO IN jacks of this unit
besicles connecting to 5.1CH INPUT jacks.
The signals through VIDEO/AUX/PHONO INjacks enable the
spectrum analyzer to work and the recording to be done.
Refer also to the operating instructions of the DVD player.
● The DIOLBY DIGITAL SURROUND sound cannot be recorded
in any way.
LISTENING TO DOLBY DIGITAL SURROUND ~
SOUND
VIDEO/ -
AUX/
PHONO
5.1CH
When a DVD player is connected to 5.1CH INPUT jacks of this
unit, you can listen to DOLBY DIGITAL SURROUND sound, which
enables you to enjoy theater-quality sound in your home.
7 Press VIDEO/AUX/PHONO 5.1 CH repeatedly until
“5.1 ch IN” is displayed.
DOLBY DIGITAL SURROUND is turned on.
2 Start playing DOLBY DIGITAL SURROUND sound
on the DVD player.
● The DOLBY PRO LOGIC and the DSP SURROUND system
are automatically canceled when the 5.1CH is selected.
● Make sure the software played back with the connected
equipment support the DOLBY DIGITAL SURROUND.
● The function is changed from the 5.ICH to the VIDEO when:
- the headphones are plugged in.
- the DSP SURROUND system or the DOLBY PRO LOGIC is
turned on.
To adjust the sound levels of the center and surround
speakers in DOLBY DIGITAL SURROUND
1
2
3
a
Press VIDEO/AUX/PHONO 5.1CH repeatedly until “5.lch IN”
is displayed.
DOLBY DIGITAL SURROUND is turned on.
Press MANUAL SELECT (TEST) on the remote control
repeatedly.
Speaker name appear in turn as follows:
~cEN(c;;r;s=
S-R (Surround Right) —
Press + or W to adjust the sound level while “CEN,” “S-
L“ or “S-R is displayed.
Each level can be adjusted between -8 dB and +7dB.
Repeat steps 2 and 3 to adjust each speaker’s sound level.
Ifthe surround speakers or the center speaker level of the DOLBY
DIGITAL SURROUND is changed, that of the DSP SURROUND
system (page 7) and the DOLBY PRO LOGIC (page 15) is also
changed.
ENGLISH 20