Filter
Top Products
2
1 Press CLOCWDIMMER once, then press ENTER
The unit can be turned off automatically at a specified time.
within 4 seconds..
1 Press SLEEP on the remote control.
When using the remote control
2
Press CLOCK, then press II SET within 4 seconds.
2 Turn
MULTI JOG to designate the hour, then press
ENTER.
The hour stops flashing and the minute starts flashing.
Within 4 seconds, turn MULTI JOG or press -
or -to specify the time until the power is turned
off .
The time changes between 5 and 240 minutes in 5-minute
steps.
Specified time
3 Turn MULTI JOG to designate the minute, then
press ENTER.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To display the current time
Press CLOCWDIMMER once. The time is displayed for 4 To check the time remaining until the power is turned off
seconds.
Press SLEEP once. The remaining time is displayed for 4
However, the time cannot be displayed during recording.
seconds.
To switch to the 24-hour standard
To cancel the sleep timer
Press CLOCK/DIMMER once and then press W within 4
Press SLEEP twice so that “SLEEPOFF appears on the display.
seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
* u and w are also available instead of MULTI JOG.
* //SET
jS a/so avaj/ab/e instead of ENTER.
~7 ENGLISH