Filter
Top Products
32
ENGLISH
LISTENING TO EXTERNAL SOURCES
PLAYING AN EXTERNAL ANALOG
SOURCE
To play equipment connected to either the VIDEO1/DVD/AUX
or the VIDEO2/LD/MD jacks, proceed as follows.
1
Select input.
To play the equipment connected to the VIDEO1/DVD/AUX
jacks, hold down VIDEO1/DVD/AUX.
To play the equipment connected to the VIDEO2/LD/MD
jacks, hold down VIDEO2/LD/MD.
“ANALOG” and “DIGITAL” appear alternately on the display.
Release the button when “ANALOG” is shown.
Analog input from your equipment is selected as the source.
2
Play the connected equipment.
To change the source name display
When the analog source is selected with VIDEO1/DVD/AUX,
“VIDEO1” is displayed initially as the source name. It can be
changed to “DVD” or “AUX”.
Similarly, “VIDEO2” is initially displayed for the analog source
selected with VIDEO2/LD/MD, but can be changed to “LD” or
“MD”.
With the power on, hold down the desired function button
(VIDEO1/DVD/AUX or VIDEO2/LD/MD) and press POWER
repeatedly to select a name.
To adjust the sound level of the external source
This unit is equipped with the overload indicator. When analog
signal input from the connected equipment is too high,
“OVERLOAD” lights up continuously on the display.
When this occurs, or when the sound level of the external source
is much lower than that of other function sources, adjust it as
follows.
1 Hold down either VIDEO1/DVD/AUX or VIDEO2/LD/MD to
select analog input and play the equipment.
2 Press f or g so that the sound level becomes the same
as that of other function sources.
NOTE
• During recording, the sound level cannot be adjusted.
• Only the sound level for analog external sources can be
adjusted. If f or g is pressed when a digital external
source is selected, the sound level for the corresponding analog
external source is changed.
PLAYING AN EXTERNAL DIGITAL SOURCE
To play equipment connected to either the DIGITAL IN OPTICAL
or the DIGITAL IN COAXIAL jack, proceed as follows.
1
Select input.
To play the equipment connected to the DIGITAL IN
OPTICAL jack, hold down VIDEO1/DVD/AUX.
To play the equipment connected to the DIGITAL IN
COAXIAL jack, hold down VIDEO2/LD/MD.
“ANALOG” and “DIGITAL” appear alternately on the display.
Release the button when “DIGITAL” is shown.
The DIGITAL indicator lights up on the display, and digital
input from your equipment is selected as the source.
2
Play the connected equipment.
To play Dolby Digital software
This unit is equipped with a Dolby Digital decoder. You can enjoy
theater-quality audio right in your home if you play a Dolby Digtal
software on a compatible video equipment connected digitally
to this unit.
To play Dolby Digital software, see section “Dolby Surround”
(pages 21 to 24).
NOTE
• This unit supports Dolby Digital bitstream signals, and linear
PCM signals with a sampling frequency of 32 kHz, 44.1 kHz or
48 kHz. This unit cannot play software whose sampling
frequency is 96 kHz.
• Some DVD players connected digitally to this unit may cause
noise during some DVD operation such as when searching a
disc, skipping a chapter, etc.