Filter
Top Products
To stand the AM antenna on a surface
Fix the claw to the slot.
To position the antennas
FM feeder antenna:
Extend this antenna horizontally in a T-shape and fix its ends to
the wall.
AM loop
antenna:
Position to find the best direction.
mB
* Be sure to connect the speaker cords correctly. Improper
connections can cause short circuits in the SPEAKERS
terminals.
* Do not leave objects generating magnetism near the speakers.
~ Do not bring the FM antenna near metal objects or curtain rails.
~ Do not bring the AM antenna near other optional equipment,
the stereo system itself, the AC cord or speaker cords, since
noise will be picked up.
* Do not unwind the AM antenna wire.
PO!NTIONING THE SPEAKERS
Position the speakers to make the most of the DSP surround
effect.
Standard positioning
L_–_
SX-NAV900u
+
SX-R220
((( :=,
,,..
@ Front speakers
@ Surround speakers
Place the surround speakers behind the listening area.
To
mount the surround speakers on the wall
Mount each speaker on a snot that can hold its weiaht.
CONNECTING AN CNJTDOOR ANTENNA
For better Flvl reception, use of an outdoor antenna is
recommended.
Connect the outdoor antenne to the FM 75 Q terminals.
To
connect other optkmial equipment + page 20.
I
REMOTE CONTROL
Inserting batteries
Detach the battery cover on Ithe rear of the remote control and
insert two R6 (size AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote contrc)l
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
m
● If the unit is not going to be used for an extended period clf
time, remove the batteries tcl prevent possible electrolyte
leakage.
● The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (television, etc.)
Sound is not heard from the surround speakers when the DSP
surround is set to off.