Filter
Top Products
Speaker system SX-INAV900
-
SPECIFICATIONS
Main unit CX-NV9000
FM tuner section
Tuning range
Usable sensitivity (IHF)
Antenna terminals
Ahrftuner section
Tuning range
Usable sensitivity
Antenna
Amplifier section
Power output
Total harmonic distortion
Inputs
outputs
Cassette deck section
Track format
Frequency response
Signal-to-noise ratio
Recording system
Heads
87.5 MHz to 108 MHz
13.2 dBf
75 ohms (unbalanced)
530 kHz to 1710 kHz (10 kHz
step)
531 kHz to 1602 kHz (9 kHz step)
350 pV/m
Loop antenna
120 watts per channel, Min.
RMS at 6 ohms, from 50 Hz to
20 kHz, with no more than 17.
Total Harmonic Distortion
0.1 % (75 W, 1 kHz, 6 ohms, DIN
AUDIO)
VIDEO/AUX: 200 mV (adjustable)
MIC 1, MIC 2: 1.3 mV (10 kohms)
LINE OUT 200 mV
SUPER WOOFER: 2.7 V
SPEAKERS: accept speakers of
6 ohms or more
SURROUND SPEAKERS:
accept speakers of 16 ohms or
more
PHONES (stereo jack): accepts
headphones of 32 ohms or more
4 tracks, 2 channels stereo
Cr02 tape: 50 Hz – 16000 Hz
Normal tape: 50 Hz – 15000 Hz
60 dB (Dolby B NRON, CrOztape
peak level)
AC bias
Deck 1: Plavback head x 1
Deck 2: Re;ording/pIayback/
erase head x 1
Compact disc player section
Laser
Semiconductor laser (1= 780 nm)
D-A converter
1 bit dual
Signal-to-noise ratio
90 dB (1 kHz, OdB)
Harmonic distortion
0.03 % (1 kHz, OdB)
Wow and flutter
Unmeasurable
Cabinet type
Speakers
Impedance
Output sound pressure level
Dimensions (W x H x D)
Weight
General
Power requirements
Power consumption
Dimensions of main unit
(W XHXD)
Weight of main unit
3 way, bass reflex (magnetic
shielded type)
Woofer:
140 mm
(55/8 h.) cone type
Tweeter:
60 mm (23/[1in.) cone type
Super tweeter:
20 mm
(’3/16 in.) Cf?rarnk type
6 ohms
87 dBIWlm
235 x 302 x 250 mm (93/11x 12 x
97/0in.)
3.5 kg (7 Ibs 11
OZ.)
120 V AC, 60 tiz
120W
260 x 308 x 344 mm
(10’/4X 12’/, X 135/8in.)
8.9 kg (19 Ibs 10 OZ.)
Specificationsand externalappearanceare subjectto change without
notice.
The word “BBE” and the “ElBE:symbol” are trademarks of ElBE;
Sound, Inc.
Under license from BBE sclund, Inc.
DOLBY NR
Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation.
“DOLBY and the doubIe-Dl symbol IIU are trademarks of Dolby
Laboratories Licensing Corporation.
❑
COPYRIGHT
Please check the laws on copyright relating to recordings fl’orn
discs, radio c)rexternal tape folrthe country in which the machin(e
is being used.
NOTE
This equipment has been tested and found to comply with the
limits for a Cllass B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions,
may cause harmful interference tc) radio
communications. However, there is no guarantee thalt
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user isencouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
CAUTION
Modifications or adjustments to this prc~duct, which are not
expressly approved by the manufacturer, may void the user’s
right or authority to operate this product.
ENGLISH 22