Filter
Top Products
BASIC RECORDING
This section explains how to record from the tuner, CD player, or
external equipment.
.’, ._ ,,. ,_
4
‘1
Preparation
● Set the tape to the point where recording will start.
● Use Type I (normal) and Type II (high/CrOz) tapes for recording.
1
2
3
4
5
Insert the tape to be recorded on into deck 2.
Insertthe tapewiththesideto be recordedonfirstfacing
out from the unit
and the exposed side down.
A
I
4
Press the REV MODE button to select the reverse
mode.
To record on one side only, turn on =.
To record on both sides, turn on 1) or C=).
Press the DOLBY NR button to turn Dolby NR on
or off.
To record with DOLBY NR, turn on m NR.
To record without DOLBY NR, turn off UI NR.
Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press the CD button and load the
disc(s).
To record from a radio broadcast, pressthe TUNER button
and tune in to a station.
To record from the connected source, press the VIDEO/
AUX button and play.
Press the ● REC/REC MUTE button to start
recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, pressthe
■ button.
To pause recording, press the 11 button. (Applicable when the
source is TUNER, VIDEO/AUX.) To resume recording, press
again.
To start recording with the remote control
First press the ●
/0 REC/REC MUTE button, and then press
the + F button within 2 seconds.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables activation of the
Music Sensor function. (Applicable when the source is TUNER
or VIDEO/AUX.)
1
2
Press the. REC/REC MUTE button during recording or
while in recording pause mode.
~ on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode,
Press the II button to resume recording.
To insert a blank space of less than 4 seconds, press the
●
REC/REC MUTE button again while ~ is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press the
● REC/REC MUTE
button again. Each time the button is pressed, a 4-second blank
space is added.
To erase a recording
Make sure the microphone is not connected to this unit.
1 Insert the tape to be erased into deck 2 and press the TAPEI
DECK 112button to display “TAPE 2.
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing the REV MODE button.
4 Press the
● REC/REC MUTE button to start the erasure.
13 ENGLISH