Appendix
80
Possible Exceptions
Exception Cause
AC power off Unplugged or AC failed
AC power on Plugged in or AC turned on
Audit table lost N/A
Coin drop 1 pulse too
short
Bad coin, fishing of drop, or incorrect coin acceptor set up.
Coin drop1 pulse too
long
Bad coin, fishing of drop or incorrect coin acceptor set up.
Coin drop2 pulse too
long
Bad coin, fishing of drop or incorrect coin acceptor set up.
Coin drop2 pulse too
short
Bad coin, fishing of drop or incorrect coin acceptor set up.
Drain time too long
Drain time is greater than 15 minutes. This is only logged,
no action is taken.
Factory reset N/A
Fill time too long
Fill time is greater than 30 minutes. This is only logged, no
action is taken.
Fill time too short
Fill time is less than 2 minutes. This is only logged, no
action is taken.
Free vend given
during service
routine
N/A
Internal backup table
bad
N/A
Internal main table
bad
N/A
Internal table lost Controller lost one of its setup tables
Invalid owner ID
Bad ID from Palm
™
handheld
Manual back in
service
N/A
Manual out of service
Service person entered a manual command on control
board to indicate “OFF” on display.
Reserved internal
exception
N/A
Service table lost N/A
Setup table lost N/A
Time: Fall back Return to Standard Time
Time: Spring
Forward
Daylight Savings
Washer lid did not
open
Washer lid switch must be detected as open before it is
allowed to run another wash cycle. The washer displays
=OFF= on the display until the service routine is run. See
product Tech Sheet or Service Manual/Job Aid for Service
Routine Procedure. Possible defective lid switch.
