Data exchange between PDA & Machine
45
Using the Utilities Command
The Utilities command, located on the Select a
command
screen, displays options for managing
your machines. Many of these options can also be
accessed directly from the control board on the
machine.
• Service mode - Places the machine into Service
Mode. This option can be used in place of
pressing the service switch on the machine. See
the Service Tech Sheet or Service Manual for
more information on placing the machine in
Service Mode.
• Start cycle - Allows the service person to start a
cycle without depositing any coins.
• End cycle - Ends the current cycle that is
running.
• Run diagnostic - Checks machine’s internal
data to ensure integrity.
• Machine info - Displays the processor’s serial
number, machine ID, location ID, and software
version number.
• Set time - Sets the machine’s internal clock
based on the time and date that is on the Palm
™
handheld. The time is set automatically during
initial setup of the machine, however use Set
time if manual set up is required.
• Get time – Displays the machine’s current time
and date settings.
