CGI Command Manual
49
・SNC-CH180, CNC-DH140/140T/180/220/220T/240/240T/260/280： 0 – 2399
( Integer)
FzAbsoluteZF "<zoom>,<focus>" - focuszoom.cgi 1.00
A zoom and a focus are adjusted to the absolute value at the same time.
<zoom>：
SNC-CH140/220/240/260/280： Value is ignored.
SNC-CH180, SNC-DH140/140T/180//220/220T240/240T/260/280： 0 – 1599
( Integer)
<focus>：
SNC-CH140/220/240/260/280： 0 – 899 ( Integer)
SNC-CH180, SNC-DH140/140T/180/220/220T/240/240T/260/280： 0 – 2399
( Integer)
FzRelativeZoom "<zoom>" - focuszoom.cgi 1.00
Relativity moves a zoom. A focus doesn't follow it.
<zoom>： -1599 - 1599 ( Integer)
FzRelativeFocus "<focus>" - focuszoom.cgi 1.00
Relativity is moved through the focus.
<focus>：
SNC-CH140/220/240/260/280： -899 – 899 ( Integer)
SNC-CH180, SNC-DH140/140T/180/220/220T/240/240T/260/280： -2399 –
2399 ( Integer)
FzRelativeZF "<zoom>,<focus>" - focuszoom.cgi 1.00
A zoom and a focus are adjusted to the relative value at the same time.
<zoom>：-1599～1599 ( Integer)
FzZoomMovementRange "<wide end>,<tele end>" focuszoom - 1.00 The range of a zoom is returned. ”0”,”1599”
FzFocusMovementRange "<far end>,<near end>" focuszoom - 1.00
The range of the focus is returned.
SNC-CH140/220/240/260/280："0","899"
SNC-CH180, SNC-DH140/140T/180/220/220T/240/240T/260/280："0","2399"
The command which can't be used in each model is shown in the following table.
