Settings
133
Select an access point to be edited from the list or select
Options
→
New access point
. Then, fill in the following
fields:
Note
: Follow the instructions given to you by your service
provider very carefully.
•
Connection name
: Enter a descriptive name for the
connection.
•
Data bearer
: Select a network bearer.
•
Access point name
: The access point name is needed to
establish a connection to the network. You obtain the
access point name from your service provider.
•
User name
: Enter a user name if required by the service
provider. The user name may be needed to make a data
connection, and is usually provided by the service provider.
The user name is often case-sensitive.
•
Prompt password
: If you must enter a new password
every time you log on to a server, or if you do not want to
save your password to the phone, choose
Yes
.
•
Password
: A password may be needed to make a data
connection, and is usually provided by the service provider.
Enter the password. Be careful as it may often case-
sensitive.
•
Authentication
: Choose a user authentication mode,
Normal
or
Secure
.
•
Homepage
: Depending on what you are setting up, enter
either the URL address of the web service or the address of
the multimedia messaging centre.
If you select
Options
→
Advanced settings
, you can set the
following options:
•
Network type
: Change a network type to either
IPv6
or
IPv4
.
•
Phone IP address
(IPv4): Enter the IP address of your
phone.
