PROGRAMMED STATION MESSAGES
Any station may select one of 20 or 30 messages to be displayed at a calling
party’s keyset (20 for iDCS 500-M version software and 30 for iDCS 500-L version
software). Ten messages are factory-programmed but may be reprogrammed. On
iDCS 500-L version software two can be individually customized, i.e., RETURN
ON: MAR/22 and RETURN AT 3:30p the remaining messages can be customized
by the system administrator (16 characters maximum).
NOTE: The calling party must have a display keyset to view these messages.
PROTECTION FROM BARGE-IN
Each station can be programmed as secure or not secure. Secure stations cannot
be barged-in on. A station that is not secure cannot be barged-in on when talking
to a secure station.
REDIAL
There are three types of external redial available to all station users. Each type can
redial up to a maximum of 18 digits.
! AUTO RETRY—When an outside number is dialed and a busy signal is received,
the auto retry feature can be used to reserve the outside line and automatically
redial the number for a programmable number of attempts (available to keyset
users only).
! LAST NUMBER—The most recently dialed number on a C.O. line is saved and
may be redialed by pressing the redial key or dialing the LNR access code.
! MANUAL RETRY with LNR (iDCS 500-L version software only)—When you make
an outside call and receive a busy signal you can press the LNR key to redial
the same number again. This operation can be manually repeated for a limited
number of attempts as defined by system programming (available to keyset
users only).
! MEMO REDIAL (iDCS 500-L version software only)—When you are calling di-
rectory assistance you can store the number you are given using the dial pad
and SAVE number feature. There is no need for a pencil and paper (available
to keyset users only).
! SAVE NUMBER—Any number dialed on a C.O. line may be saved for redial at
a later time.
4.37
