Pelco Manual C1402M-B (2/98) 19
3.6 ADJUSTMENTS
To adjust the pan limits, perform the following steps. Refer to Figure 12 for limit stop
locations. Factory pan limits are set at 0-355°, tilt limits are set at 0-90° (horizontal
to vertical).
To adjust limit stops, perform the following steps:
1. Pan unit to the desired left or right position; adjust the appropriate limit stop
position. If necessary, disconnect drive from back box to make required ad-
justments.
2. Replace drive in back box. Again, pan unit to left and right limit stop positions.
If position of stops is incorrect, repeat the procedure in step 1.
3. Pan to the right and left to verify the exact positioning and tighten both stops
securely.
4. The tilt limit is designed to allow for 0-90° travel (horizontal to vertical).
LIMIT STOPS
LIMIT STOPS
Figure 12. Limit Stop Locations
CAUTION:
Do not at-
tempt to adjust limit stops
when the pan/tilt is in op-
eration. Damage to the
equipment can result.
Do
not
operate pan/tilt with-
out limit stops.
Do not
remove or repo-
sition fixed limit stop.
DAMAGE WILL OC-
CUR.
Note the SL models are
supplied without pan limit
stops, therefore, no ad-
justments are necessary.
