Pelco Manual C1402M-B (2/98) 15
3.3.3 Camera/Lens Installation
Install the camera/lens that you have selected for use with the SB2600 Series dome
as follows:
1. Loosen the 1/4-20 lens support fastener and slide lens support down (see
Figure 8).
2. Place camera/lens atop the tilt table and thread the provided 1/4-20 x 1/2-inch
fastener through the tilt table into the camera (see Figure 8). Snug the fastener
at this time to allow for camera/lens repositioning.
3. Connect camera power spade lugs, coax video cable and lens connector, paying
special attention to the routing of the cabling so as not to interfere with the
camera/lens swing.
4. Ensure there is sufficient initial clearance between the camera/lens and dome
as you carefully attach dome to drive unit as shown in Figure 9. Align the four
ball stud receivers on the dome drive and push dome until snapping sound
occurs. You are now ready to tilt the camera/lens combination up and down to
check for clearance between the lens and the dome. If proper clearance is not
achieved, the dome will be dislodged from the dome drive. Also pay attention
to camera and wiring clearance up inside the drive.
5. Adjust camera/lens and wire routing as necessary to achieve proper clear-
ances. Always keep in mind that if the camera/lens can be balanced the unit
life will be extended.
6. After satisfactory clearances have been achieved, remove dome and tighten
all three camera/lens fasteners. The unit is now ready for operations test and,
if applicable, pan limit stop adjustments.
(3)
(2)
(1)
BALL STUD RECEIVERS
Figure 8. Attaching Camera/Lens to Tilt Table Figure 9. Attaching Dome to Drive Unit
NOTE:
Remove “shipping
bracket” at this time. Refer to Fig-
ure 14, item 65.
NOTE:
Fixed speed units must
have power on and you must be
able to activate the tilt functions.
Do
not rotate fixed speed dome
caves by hand. Damage will oc-
cur to the motors.
