96 GPSMAP 3006C/3010C Owner’s Manual
usIng radar > radar Page
radar
Acquiring target
Dangerous target
Safe
targets
To view the MARPA List:
PresstheMARPA Listsoftkey.
Enter Standby (Begin Transmitting)
The Enter Standby (Begin Transmitting) option allows you to select if the radar
is in Standby Mode or is transmitting. Select Enter Standby to place the radar
into Standby Mode. While in Standby Mode, the radar does not transmit, but
power remains applied to the Magnetron. Select Begin Transmitting to remove
the radar from Standby Mode. After the radar completes “Spinning Up”, the radar
begins transmitting.
Set Motor to High Speed (Set Motor to Normal Speed)
The Set Motor to High Speed (Set Motor to Normal Speed) option allows you
to select the motor speed of the GMR 404/406 radar. Selecting Set Motor to
High Speed to increases the speed at which the radar rotates, thus increasing the
speed at which the screen updates.
NOTE: This option is available only if you are using a GMR 404/406 Radar.
