Filter
Top Products
23
English
INTRODUCTION
PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
CONNECTIONSADJUSTING SPEAKER OUTPUT LEVELS
4 Adjust the level of the
effect speakers using j / i
so that it matches the
level of the main
speakers.
While adjusting, the test tone
is heard from the selected
speaker.
Note
• To adjust the level of the main speakers, use VOLUME knob
(or VOL +/– on the remote control).
5 When adjustment is
complete, press TEST to
stop the test tone.
Notes
• If “1A CENTER” on the SET MENU is set to NON, the center
channel sound is automatically output from the main left and
right speakers.
• If “1C REAR LR” on the SET MENU is set to NON, the
output level of the rear left, right and center speakers cannot be
adjusted in step 4. The test tone will be circulated skipping the
rear left and right speakers and the rear center speaker.
• If “1D REAR CT” on the SET MENU is set to NON, the
output level of the rear center speaker cannot be adjusted in
step 4. The test tone will be circulated skipping the rear center
speaker.
• If “1E BASS” on the SET MENU is set to MAIN, the test tone
will be circulated skipping the subwoofer.
y
• It is not necessary to readjust the speaker levels once they are
set (as long as you do not change the speakers). You can enjoy
listening to or watching the input source at the desired volume
simply by adjusting the VOLUME knob (or VOL +/– on the
remote control).
• If the output level of the effect speakers (center, rear left, rear
right, and rear center) cannot be increased enough to match the
level of the main speakers, set “1F MAIN Lv” on the SET
MENU to –10 dB (see page 44). This setting decreases the
main speaker output level to about one-third of the normal
level. After you have set “1F MAIN Lv” on the SET MENU to
–10 dB, adjust the levels for the center and rear speakers again.
* Subwoofer test tone is output after the rear left
speaker (LEFT SURROUND).
For your convenience, the state of the test tone
output is also shown on the monitor by an image of
an audio listening room.
The front panel display also shows which speaker is
outputting the test tone.
Note
• If the test tone cannot be heard, turn down the volume, set this
unit to standby mode and check the speaker connections.
LEFT
TEST DOLBY SUR.
TV VOL
PRESET PRESET
TV MUTE
TV VOL
SELECT
CHCH
+
+
–
–
LEFT SURROUND RIGHT SURROUND
CENTER
REAR CENTER
RIGHT
LEFT
*
SUBWOOFER
TEST
RETURN
0104V730_19-23_EN(U) 12/27/01, 2:17 PM23