Filter
Top Products
53
English
SYMPTOM
FM stereo reception is noisy.
There is distortion and clear
reception cannot be obtained even
with a good FM antenna.
The desired station cannot be tuned
in with the automatic tuning method.
Previously preset stations can no
longer be tuned in.
The desired station cannot be tuned
in with the automatic tuning method.
There are continuous crackling and
hissing noises.
There are buzzing and whining
noises (especially in the evening).
The remote control transmitter does
not work.
The sound is degraded when
listening with headphones to a
CD player or tape deck that is
connected to this unit.
CAUSE
Because of the characteristics of FM
stereo broadcasts, this is limited to
cases where the transmitter is too far
away or the antenna input is poor.
There is multipath interference.
The station is too weak.
This unit has been unplugged for a long
period.
Weak signal or loose antenna
connections.
Noises will result from ligtning,
fluorescent lamps, motors, thermostats
and other electrical equipment.
A television set is being used nearby.
Direct sunlight or lighting (of an inverter
type of fluorescent lamp etc.) is striking
the remote control sensor of the main
unit.
The manufacturer’s code is not set
properly.
The proper manufacturer’s code for the
component to be controlled is not set.
The component to be controlled is not
selected.
This unit is in the standby mode.
REMEDY
Check the antenna connections.
Try using a high quality directional FM
antenna.
Set TUNING MODE to the manual
tuning mode.
Adjust antenna placement to eliminate
multipath interference.
Use the manual tuning method.
Use a high quality directional FM
antenna.
Repeat the presetting procedure.
Tighten the AM loop antenna
connections and rotate it for best
reception.
Use the manual tuning method.
Use an outdoor antenna and a ground
wire. This will help somewhat but it is
difficult to eliminate all noise.
Relocate this unit away from the TV.
Change the position of the main unit.
Set the code again.
Try entering another code for the same
manufacturer.
Set the SELECTOR DIAL to the proper
position.
Turn the power of the unit on.
Remote control transmitter
AM FM
Others
01RX-V595-e/f7 6/23/99, 4:12 PM53