14
To cancel program play mode
Press ALL, +1 DISC, or GROUP (A – E) during program play
mode. Program play mode will be canceled.
To check program data
1. Press STOP to stop program play.
2. Press PROG.
3. Press SKIP
. Each time you press this button, the disc
and track number and the program number are displayed
in the order of the program. When you want to check the
preceding disc or tracks, press SKIP
.
Note
• When you program an entire disc as one step, “AL” appears
in the display when you press SKIP to check program data.
To change program data
1. Follow the preceding procedure described in “To check
program data.”
2. Display the disc or track number to be deleted or corrected
by pressing SKIP.
3. Press DISC SKIP to select the desired disc and press the
number button of the desired track you want to substitute
for the one currently displayed.
( When you want to program an entire disc as one step,
press 0 after pressing DISC SKIP.)
4. Press ENTER.
The previously programmed track or disc will be cleared
from the memory and the new one will be programmed.
If you want to delete the programmed track or disc
currently displayed, press DELETE before pressing
ENTER.
5. When you are finished, press PROG or PLAY.
Note
• When you program an entire disc as one step, “AL” appears
in the display when you press SKIP to change program data.
To delete all program data
1. Follow of steps 1 and 2 of the procedure described in “To
check program data.”
2. Press and hold DELETE for more than 5 seconds.
3. “DELETE” appears for a moment, then “ALL DELETE”
appears and the entire contents of memory is deleted.
Notes
• When you change to program play mode from another play
mode, press STOP and PROG (“PROG” appears in the
display), then press PLAY to start program play.
• To select a disc directly, press DISC, the number button of
the desired disc and ENTER, or turn the JOG dial on the
front panel in step 3 of the previous page.
• SKIP (
and ) can be used during program play to
skip to tracks within the program.
• SEARCH ( and ) can be used during program play
to search all tracks, including unprogrammed tracks.
• Even if you press POWER to turn the unit off, the programs
you have set remain in the unit’s memory.
• If you program a track that is not included in a disc, “ERROR”
appears in the display.
• If you program an entire disc as one step, “1” appears in the
display during program play.