Open as PDF
Adjusting the Level
■ Adjusting the level of signals output
into an amplifier, etc.
You can adjust the level of sound signals output from the
LINE OUT terminals on the rear panel into an amplifier,
etc. as you prefer by using the OUTPUT LEVEL –/+
For optimum sound quality
* When the DIGITAL AUDIO OUT (OPTICAL) terminal
is used for the connection, set the level of output signals
* The level of output signals can be checked in the display.
■ When you listen with headphones
Connect the headphones to the PHONES jack and adjust
the volume by using the OUTPUT LEVEL –/+ buttons.
* Note that the use of the OUTPUT LEVEL –/+ buttons
will also vary the level of the signal output to an
You can start play at any specified time by connecting a
timer (sold separately). Refer also to the instructions for the
1 Select the desired play mode (1DISC or 5DISCS).
2 Press the POWER switch to turn the unit off.
3 Press the POWER switch while pressing the w/d button
on the front panel.
Shortly thereafter, “TIMER P. ON” appears in the
display and the timer play function is on.
(When the timer play function is already on, in which
case, “TIMER P. OFF” appears in the display and timer
play function is off. In this case, repeat the procedure in
steps 2 and 3 to set the timer play function to on.)
4 Set the timer to the desired time.
When the set time comes, the unit turns on and starts
On the front panel
11 12 13 14 15
16 17 18 19 20
NATURAL SOUND COMPACT DISC PLAYER
1 2 3
PROG 1 2 3 4 5
+10 6 7 8 9 0