Filter
Top Products
E-19
English
VIDEO CD PLAYER OPERATION
PLAYXCHANGE
During playback, you can open the disc table by pressing the
DISC CHANGE button without interrupting playback.
However, in this case, pressing the DISC SKIP button or a
DISC selector button is invalid.
Note
You can load or replace discs on the trays when the disc
table is opening, however, never load a disc on the tray
hidden inside the unit. In doing so, the disc and the unit may
be damaged, because the tray already has a disc, which is
being played back.
6 If necessary, select another disc by pressing the DISC
SKIP button on the remote control transmitter once or
more (so that the corresponding disc tray number is
located on the top of the disc indicator).
7 Press the play/pause / button to start playback from
track 1.
* The “ ” indicator will appear and playback will begin.
As the playback of each track on the music calendar is
finished, that track number will go out.
For easier operation
Pressing the DISC selector button (1, 2 or 3) will select the
disc directly, and playback will begin from track 1
automatically
Note
If a Video CD, version 2.0 is selected, “PBC” lights up on the
display, yet the total number of tracks, the total playing time
of the disc and the music calendar will not be displayed. In
this mode, disc playback is controlled by the rule of Playback
Control. (For details of Playback Control, refer to page
27–29.)
To cancel this mode and restore the normal playback mode,
press the RETURN (
) button on the remote control
transmitter. “PBC” disappears from the display.
To call the Playback Control mode again, press and hold the
RETURN (
) button on the remote control transmitter for
more than 2 seconds.
To interrupt playback
11 Press the play/pause / button.
* The “ ” indicator will flash.
22 Press the play/pause / button to resume playback
from the same point.
To stop playback
Press the stop button.
To turn the unit into the standby mode after use
Turn this unit into the standby mode by pressing the
STANDBY/ON switch. (The indicators will go off except for
the current time display.)
Direct playback
When this unit is in the standby mode, pressing the DISC
selector (1, 2 or 3) button will turn the power on and start disc
playback automatically.
When the power is on, even if an input source other than
Video CD player is selected, pressing a DISC selector button
or closing the disc table by pushing the front edge of the disc
table gently will start playback directly.
* These ways of playback can also be used to close the disc
table. If the table is closed in these ways, playback will
begin automatically, however, the display will not show the
total number of tracks and the total playing time of the disc
to be played back.
Direct operation
When this unit is in the standby mode, pressing the following
buttons will turn the power on and perform their own
functions automatically.
On the front panel: OPEN/CLOSE, DISC (1, 2, 3),
INPUT SELECTOR (VCD/CD, TUNER)
On the remote control transmitter:
OPEN/CLOSE, VCD/CD, TUNER,
PLAY/PAUSE
Precautions
•
Subjecting the unit to shock or vibration can cause
mistracking.
•
Playing back some discs at high volume can cause
mistracking. In this case, listen at lower volume.
•
Do not pull open the disc table forcibly with your hands.
•
Do not push the disc table while it is moving.
•
If the power fails while the table is open, wait until the
power supply returns or gently push the table manually to
close it.
•
The temperature range for playing back discs is
recommended to be 5°C (41°F) – 35°C (95°F).