Filter
Top Products
30 En
You can connect a Bluetooth Wireless Audio Receiver (such as YBA-10, sold separately) to the DOCK terminal of this
unit and enjoy the music contents stored in your Bluetooth component (such as a portable music player) without wiring
between this unit and the Bluetooth component. You need to perform “pairing” for the connected Bluetooth receiver and
your Bluetooth component in advance.
Pairing must be performed when you use a Bluetooth
component with the Bluetooth receiver connected to this
unit for the first time or if the pairing data has been
deleted. “Pairing” refers to the operation of registering a
Bluetooth component for Bluetooth communications.
y
• You need to perform the pairing operation only when you use the
Bluetooth component with the Bluetooth receiver for the first time.
• You need to perform the pairing operations both on this unit and on the
Bluetooth component. If necessary, refer to operating instructions of the
Bluetooth component.
There are two pairing methods: pairing by using “START
PAIRING” in “SET MENU” and quick pairing.
■ Pairing by using “SET MENU”
Use this feature to perform pairing of this unit and the
video monitor. Select “START PAIRING” in “INPUT
MENU.” See page 36 for details.
■ Quick pairing
1 Press hAMP and then press NINPUT l /
h repeatedly (or press fV-AUX/DOCK) to
select “V-AUX” as the input source.
2 Turn on the Bluetooth component you want
to pair with.
3 Press and hold GBAND (or jBAND LEVEL
TITLE) for 3 seconds.
Once the Bluetooth receiver starts pairing,
“Searching...” appears for a moment. While the
Bluetooth receiver is in the pairing mode, DOCK
indicator flashes on the front panel display.
y
• To cancel the pairing, press GBAND (or jBAND LEVEL
TITLE) again.
Note
• If the Bluetooth receiver is not connected to the DOCK terminal of
this unit, “No BT adapter” appears on the front panel display.
4 Check that the Bluetooth component detects
the Bluetooth receiver.
If the Bluetooth component detects the Bluetooth
receiver, “YBA-10 YAMAHA” (example) appears in
the Bluetooth device list.
5 Select the Bluetooth receiver in the
Bluetooth device list and then enter the pass
key “0000” to the Bluetooth component.
When the pairing is completed successfully,
“Completed” appears on the front panel display.
Note
• The Bluetooth Wireless Audio Receiver can be paired with up to eight
other components. When pairing is conducted successfully with a ninth
component and the pairing data is registered, the pairing data for the least
recently used other component is cleared.
1 Press hAMP and then press NINPUT l /
h repeatedly (or press fV-AUX/DOCK) to
select “V-AUX” as the input source.
2 Start playback of your Bluetooth component.
When the connected Bluetooth receiver detects the
Bluetooth component, “BT connected” and the
DOCK indicator appears on the front panel display.
y
• When you press lENTER on the remote control, the connected
Bluetooth receiver searches and connect to the last connected Bluetooth
component. If the Bluetooth receiver cannot find the Bluetooth
component, “Not found” appears on the front panel display.
• To disconnect the Bluetooth receiver from the Bluetooth component,
press nRETURN.
Using Bluetooth™ components
Pairing the Bluetooth™ receiver and
your Bluetooth™ component
To ensure security, a time limit of 8 minutes is set for
the pairing operation. You are recommended to read
and fully understand all the instructions before starting.
Playback of the Bluetooth™
component