Filter
Top Products
27 En
English
INTRODUCTION
ADDITIONAL
INFORMATION APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
You can use two tuning modes to tune into a desired FM/
AM station:
■ Frequency tuning mode
You can search or specify the frequency of the desired
FM/AM station automatically or manually (see “FM/AM
tuning operations” on this page).
■ Preset tuning mode
You can preset the desired FM/AM station in advance, and
then recall the station by specifying the preset group and
number (see “Selecting preset stations” on page 28).
Note
• Orient the connected AM loop antenna, or adjust the position of the end
of the indoor FM antenna for the best reception.
1 Press NINPUT l / h repeatedly so that
“TUNER” is displayed on the front panel
display.
2 Press GBAND to select the reception band
(FM or AM).
3 To search the station automatically, press
ITUNING AUTO/MAN’L so that the AUTO
indicator lights up on the front panel display.
To search the station manually, press
ITUNING AUTO/MAN’L again so that the
AUTO indicator disappears from the front
panel display.
If a colon (:) appears on the front panel display,
automatic/manual tuning is not possible. Press
DEDIT PRESET/TUNING to turn the colon (:)
off.
4 To begin automatic tuning, press
FPRESET/TUNING l / h once. To tune
into the desired station manually, press
FPRESET/TUNING l / h repeatedly.
When this unit is tuned into a station, the TUNED
indicator lights up and the frequency of the received
station is shown on the front panel display.
• To tune into a higher frequency, press
FPRESET/TUNING h.
• To tune into a lower frequency, press FPRESET/
TUNING l.
Note
• If the signal from the station you want to select is weak, tune into it
manually.
Use this feature to store up to 40 stations (A1 to E8: 8
preset station numbers in each of 5 preset station groups).
Preset the desired stations to this unit by using the
automatic or manual station preset.
You can use the automatic preset tuning feature to store up
to 40 FM stations with strong signals in order.
1 Press NINPUT l / h repeatedly so that
“TUNER” is displayed on the front panel
display.
2 Press GBAND to select “FM” as the
reception band.
3 Press and hold HMEMORY for more than 3
seconds.
The preset station number as well as the MEMORY
and AUTO indicators flashes. After approximately 5
seconds, automatic presetting status from the current
frequency and proceeds toward the higher
frequencies.
When automatic preset tuning is completed, the front
panel display shows the frequency of the last preset
station.
FM/AM tuning
Overview
FM/AM tuning operations
AUTO
A
AM
1440
kHz
Lights up during automatic tuning
No colon (:)
Preset FM/AM stations
Automatic station preset
AUTO
TUNED
A
AM
1530
kHz
Lights up
AUTO
MEMORY
A1:FM 87.5 MHz
Flashes
Flashes