Yamaha RX-V995 Stereo Receiver User Manual


 
82
AUDIO SECTION
Minimum RMS Output Power Per Channel
(When both channels are driven)
MAIN L/R (20 Hz to 20 kHz, 0.04%
THD, 8 ohms) ....................... 100W+100W
CENTER (20 Hz to 20 kHz, 0.07%
THD, 8 ohms) ................................... 100W
REAR L/R (20 Hz to 20 kHz, 0.07%
THD, 8 ohms) .........................100W+100W
Maximum Power [China and General
models only]
1 kHz, 10% THD
, 8 ohms
(When both channels are driven)
MAIN L/R................................135W+135W
CENTER.............................................135W
REAR L/R...............................135W+135W
Dynamic Power Per Channel
(by IHF Dynamic Headroom Measuring Method)
[U.S.A., Canada, China and General models
only]
MAIN L/R (8 ohms/6 ohms/4 ohms/2 ohms)
(When both channels are driven)
...............................130W/160W/200W/240W
Dynamic Headroom
[U.S.A., Canada, China and General models
only]
MAIN L/R (8 ohms) .......................... 1.13 dB
DIN Standard Output Power Per Channel
[Singapore model only]
MAIN L/R (1 kHz, 0.7% THD, 4 ohms)
(When both channels are driven) ..... 150W
IEC Power [Singapore model only]
MAIN L/R (1 kHz, 0.015% THD, 8 ohms)
(When both channels are driven)........ 105W
Power Band Width (20 Hz to 20 kHz)
8 ohms, 50W, 0.08% THD
(When both channels are driven)
...........................................10 Hz to 50 kHz
Damping Factor
MAIN L/R (20 Hz to 20 kHz, 8 ohms)
.............................................. More than 160
Input Sensitivity/Impedance (100W/8 ohms)
CD/TAPEMD/DVDLD/TVDBS/VCR 1
/VCR 2/VIDEO AUX........ 150 mV/47 k-ohms
PHONO MM......................2.5 mV/47 k-ohms
Maximum Input Signal (1 kHz, 0.05% THD)
CD/TAPEMD/DVDLD/TVDBS/VCR 1
/VCR 2/VIDEO AUX (EFFECT ON)
................................................. 2.3V or more
PHONO MM ....................... 110 mV or more
Output Level/Impedance
REC OUT....................... 150 mV/1.0 k-ohms
PRE OUT
MAIN, CENTER, REAR
.......................................... 2.6V/1.1 k-ohms
SUBWOOFER (MAIN SP: SMALL)
(EFFECT OFF) ................ 4.0V/1.5 k-ohms
ZONE 2 OUT ...................... 1.0V/1.5 k-ohms
Headphone Jack Rated Output/Impedance
Output Level
CD/TAPEMD/DVDLD/TVDBS/VCR 1
/VCR 2/VIDEO AUX Input: 1 kHz,
150 mV, RL=8 ohms ........................... 0.5V
Impedance .................................... 440 ohms
Frequency Response (20 Hz to 20 kHz)
CD/TAPEMD/DVDLD/TVDBS/VCR 1
/VCR 2/VIDEO AUX to MAIN L/R SP OUT
....................................................... 0±0.5 dB
RIAA Equalization Deviation
(20 Hz to 20 kHz)
PHONO MM..................................0±0.5 dB
Total Harmonic Distortion (20 Hz to 20 kHz)
CD/TAPEMD/DVDLD/TVDBS/VCR 1
/VCR 2/VIDEO AUX (EFFECT OFF) to SP
OUT (MAIN L/R), 50W/8 ohms
......................................... Less than 0.025%
PHONO MM to REC OUT, 3V
........................................... Less than 0.01%
Signal-to-Noise Ratio (IHF-A Network)
CD/TAPEMD/DVDLD/TVDBS/VCR 1
/VCR 2/VIDEO AUX (Input Shorted)
(EFFECT OFF) .................. More than 96 dB
PHONO MM (Input Shorted 5 mV)
(EFFECT OFF)....................More than 86 dB
Residual Noise (IHF-A Network)
MAIN L/R SP OUT............ Less than 170 µV
Channel Separation (Vol. –30 dB)
CD/TAPEMD/DVDLD/TVDBS/VCR 1
/VCR 2/VIDEO AUX Input 5.1 k-ohms
Shorted (EFFECT OFF)
1 kHz/10 kHz ........ More than 60 dB/45 dB
PHONO MM Input Shorted (EFFECT OFF)
1 kHz/10 kHz ..........More than 60 dB/55 dB
Tone Control Characteristics
Bass
Boost/Cut ........................... ±10 dB (50 Hz)
Turnover frequency ........................ 350 Hz
Treble
Boost/Cut ......................... ±10 dB (20 kHz)
Turnover frequency ....................... 3.5 kHz
Bass Extension (MAIN L/R)
....................................................+6 dB (50 Hz)
Filter Characteristics
MAIN L/R, CENTER, REAR L/R
(MAIN, CENTER, REAR SP: SMALL)
(H.P.F.) .......................fc = 90 Hz, 12 dB/oct.
SUBWOOFER (L.P.F.)
.................................... fc = 90 Hz, 18 dB/oct.
Gain Tracking Error (0 to –60 dB)
MAIN L/R ....................................3 dB or less
Audio Muting ............................................ –
VIDEO SECTION
Video Signal Type
[U.S.A. and Canada models]................NTSC
[Australia and Singapore models] .......... PAL
[China and General models] ....... NTSC/PAL
Video Signal Level ................. 1 Vp-p/75 ohms
S-Video Signal Level
Y ......................................... 1 Vp-p/75 ohms
C .................................. 0.286 Vp-p/75 ohms
Maximum Input Level ....... More than 1.5 Vp-p
Signal-to-Noise Ratio ........... More than 50 dB
Monitor Out Frequency Response
..................................... 5 Hz to 10 MHz, –3 dB
FM SECTION
Tuning Range
[U.S.A. and Canada models]
..........................................87.5 to 107.9 MHz
[Australia, China, Singapore and General
models].............................87.5 to 108.0 MHz
50 dB Quieting Sensitivity (IHF, 75 ohms,
100% mod., 1 kHz)
[U.S.A., Canada, China and General
models only]
Mono.................................1.6 µV (15.3 dBf)
Stereo................................23 µV (38.5 dBf)
Usable Sensitivity (75 ohms)
[Australia and Singapore models only]
DIN, Mono (S/N 26 dB) .....................0.9 µV
DIN, Stereo (S/N 46 dB).....................28 µV
Alternate Channel Selectivity (±400 kHz)
[U.S.A., Canada, China and General
models only]..........................................75 dB
Selectivity (two signals, 40 kHz Dev. ±300
kHz)
[Australia and Singapore models only]
..............................................................55 dB
SPECIFICATIONS