Filter
Top Products
74
REMOTE CONTROLLER
Ⅵ Learning a new function
1 Place this remote controller and the other remote
controller so that they face each other.
2
* If there is no operation for about 30 seconds after the
LEARN button is pressed, the TRANSMIT/LEARN indicator
flashes rapidly and the current mode is canceled. Repeat
this step.
3 If necessary, select the memory area by using the A/B/C
switch on the side panel of the remote controller.
4 Press the key on this remote controller in which you will
store a new function.
* If a key which cannot learn another function is pressed, the
TRANSMIT/LEARN indicator flashes rapidly and the current
mode is canceled. Repeat this step.
* If there is no operation for about 30 seconds after a key is
pressed, the TRANSMIT/LEARN indicator flashes rapidly
and the mode before you began learning operations is
restored. Restart from step 2.
5 Press and hold the key (on the other remote controller)
which has the function you want to store.
When learning is finished, the TRANSMIT/LEARN indicator
stops lighting. You can release the key. Then the indicator
begins flashing slowly.
* If a signal is not successfully received, the
TRANSMIT/LEARN indicator flashes rapidly and the mode
prior to step 4 is restored. Restart from step 4.
* If memory capacity is full, the TRANSMIT/LEARN indicator
flashes rapidly to show you that learning is impossible, and
then the mode before you began learning operations is
restored.
6 Repeat steps 3–5 to store more functions.
7 When you finish the learning operation, press the
LEARN button.
Notes
●
Newly learned functions will replace previously learned
functions.
●
If there is no more room in the memory area for a function to
be learned, the TRANSMIT/LEARN indicator will flash
rapidly. In this case, even if some keys are not occupied
with functions from other remote controllers, no further
learning is possible.
●
If you close the cover while learning, and then about 5
seconds pass, the TRANSMIT/LEARN indicator flashes
rapidly and the mode before beginning learning operations
is restored. Restart from step 2. However, if you open the
cover within 5 seconds, the mode before closing the cover is
restored.
●
There may occasionally be instances in which, due to the
signal-coding and modulation employed by the other remote
controller, this remote controller will not be able to “learn” its
signals.
●
When you press the LEARN, MACRO or CLEAR button, or
the RESET button inside of the battery compartment by
using a sharp-pointed thing, be careful not to damage the
button. If you will use a mechanical pencil, make sure that
the lead is retracted.
V-AUX
PHONO
EFFECT
ON/OFF
123
SPORTS
STADIUM
DISCO
TV
456
ROCK
JAZZ CLUB
CHURCH
789
TEST
E
+10
Lights up.
V-AUX
PHONO
EFFECT
ON/OFF
123
ORTS
STADIUM
DISCO
TV
56
CLUB
CHURCH
9
EST
This remote
controller
Other remote
controller
About 5–10 cm
(2–4 in.)
TRANSMIT
/LEARN
LEARNCLEAR MACRO
Flashes slowly.
(Press by using a ball-point
pen or similar object.)
LEARNCLEAR MACRO
V-AUX
PHONO
EFFECT
ON/OFF
123
SPORTS
STADIUM
DISCO
TV
456
OCK
JAZZ CLUB
CHURCH
89
TEST
10
Methods of learning and clearing functions