Filter
Top Products
42
Notes on recording
●
The VOLUME, BASS, TREBLE, BALANCE controls, the
BASS EXTENSION button and the settings of DSP have
no effect on the material being recorded.
●
Composite video and S video signals pass independently
through this unit’s video circuits. Therefore, when recording or
dubbing video signals, if your video source unit is connected
to provide only a S video (or only a composite video) signal,
you can record only a S video (or only a composite video)
signal on your VCR.
●
A source that is connected to this unit between optical
digital terminals only cannot be recorded by a tape deck or
VCR other than the tape deck (or MD recorder etc.)
connected to the OPTICAL TAPE/MD OUT terminal of this
unit.
●
A source of signals input to the EXTERNAL DECODER
INPUT terminals of this unit cannot be recorded.
●
Please check the copyright laws in your country to record
from records, compact discs, radio, etc. Recording of
copyright material may infringe on copyright laws.
●
<For China, Singapore and General models only>
Dolby Digital RF audio input signal cannot be recorded by a
tape deck or VCR. To record an LD source, the LD player
must be connected to the OPTICAL digital audio signal
input terminal and/or analog audio signal input terminals of
this unit.
If you play back a video source that uses scramble or
encoded signals to prevent it from being dubbed, there may
be a case that display information superimposed on the
picture and/or the picture itself is disturbed due to those
signals.
BASIC OPERATION
Ⅵ Adjusting the BALANCE control
Adjust the balance of the output volume to the left and right
speakers to compensate for sound imbalance caused by
speaker location or listening room conditions.
Note
This control is effective only for the sound from the main
speakers.
Ⅵ Using the BASS EXTENSION
button
Press this button inward (ON) to boost the bass frequency
response at the main left and right channels while maintaining
overall tonal balance. This function is effective for reinforcing
the bass frequencies when a subwoofer is not used.
Ⅵ Adjusting the BASS and TREBLE
controls
BASS : Turn this knob clockwise to increase (or counter-
clockwise to decrease) the low frequency
response.
TREBLE : Turn this knob clockwise to increase (or counter
clockwise to decrease) the high frequency response.
Note
These controls are effective only for the sound from the main
speakers.
Ⅵ Using the TONE BYPASS button
Press this button inward (ON) to bypass the tone (BASS and
TREBLE) control circuitry. This function is used for outputting
pure sound and checking the tone control settings. The tone
control circuitry can be used when this button is released
outward (OFF).
BASS TREBLE
55
4
3
2
l
0
l
2
3
4
55
4
3
2
l
0
l
2
3
4
BASS
EXTENSION
TONE
BYPASS
BALANCE
55
4
3
2
l
0
l
2
3
4
LR
BASS
EXTENSION
TONE
BYPASS
Sound control