Filter
Top Products
28
ADJUSTING THE SPEAKER OUTPUT LEVELS
TEST DSP
Select “TEST DSP” to match the output levels of the
front effect speakers to the main speakers.
Note
• You cannot enter the “TEST DSP” mode if “1F FRONT EFCT
SP” is set to NONE.
1 Press TEST repeatedly to
output the test tone.
2 Adjust the volume so you
can hear the test tone.
The test tone is heard alternately from the front effect
speakers and main speakers. The tone is produced for
2.5 seconds each time. Press k to hear the test tone
from the front effect L speaker, and n to hear the test
tone from the front effect R speaker.
TEST
MUTE
VOLUME
STEREO
TV INPUT
TV VOL
CH
PRESET
DISC
PARAMETER
SET MENU
EFFECT
LEVEL
ON SCREEN
TESTSLEEP
TV MUTE
A/B/C/D/E
2
31, 4
VOLUME
RIGHT
FRONT
LEFT
FRONT
The state of the test tone output is also shown on the
monitor by an image of the audio listening room.
This is convenient for adjusting each speaker level.
Front panel display also indicates from which
speaker the test tone is output as follows:
TEST MAIN → TEST FRONT → TEST MAIN → …
Note
• If the test tone cannot be heard, turn down the volume, set this
unit in the standby mode and check the speaker connections.
3 Press –/+ repeatedly to
adjust the output level of
the front effect speakers
so that the output level
coming from each
speaker is the same.
While adjusting, the test tone is heard from the front
effect speaker.
Note
• Main L/R speaker level cannot be adjusted by itself. Use
VOLUME to adjust the main volume.
4 When the adjustment is
complete, press TEST to
stop the test tone.
y
• It is not necessary to readjust the speaker level once it is set as
long as you do not change the speakers. You can enjoy listening
to or watching the input source with the desired volume by
adjusting the volume key.
• You can increase the output levels of the front effect speakers
to +10 dB. If the output level of these speakers is lower than
that of the main speakers even after you have increased the
output level of these speakers up to +10 dB, set “1G MAIN
LEVEL” on the SET MENU to –10 dB (see page 64). This
setting decreases the main speaker output level to about one-
third of the normal level. After you have set “1G MAIN
LEVEL” on the SET MENU to –10 dB, adjust the levels for
the center and rear speakers again.
MAIN
TEST DSP
TEST
0104V3300_24-28_EN(UA) 02.7.24, 6:05 PM28