Filter
Top Products
PREPARATIONS ➤ Connecting speakers En 23
■
Connecting front speakers that support bi-amp connections
When using front speakers that support bi-amp connections, connect them to the
FRONT terminals and EXTRA SP terminals.
To enable the bi-amp function, configure the “Power Amp Assign” setting (p.103) in the
“Setup” menu after connecting the power cable to an AC wall outlet.
• The FRONT terminals and EXTRA SP terminals output the same signals.
■ Connecting Zone2 speakers
When using Zone2 speakers, connect them to the EXTRA SP terminals.
To utilize the EXTRA SP terminals for Zone2 speakers, configure the “Power Amp
Assign” setting (p.103) in the “Setup” menu after connecting the power cable to an AC
wall outlet.
• You can also connect Zone2 speakers using an external amplifier (p.81).
Caution
• Before making bi-amp connections, remove any brackets or cables that connect a woofer with a
tweeter. Refer to the instruction manual of the speakers for details. If you are not making bi-amp
connections, make sure that the brackets or cables are connected before connecting the speaker
cables.
SPEAKERS
CENTER FRONTSURROUND BACKSURROUND
BI–AMP
ZONE 2/F.PRESENCE/
R L R R RL L L
SINGLE
EXTRA SP
12
3
9
45
9
The unit (rear)
SPEAKERS
CENTER FRONTSURROUND BACKSURROUND
BI–AMP
ZONE 2/F.PRESENCE/
R L R R RL L L
SINGLE
EXTRA SP
12
3
45
76
99
The unit (rear)
Main zone
Zone2
1
Speaker connections
2 3 4 5 6 7 8 9