Filter
Top Products
CONFIGURATIONS ➤ Configuring various functions (Setup menu) En 109
HDMI
Configures the HDMI settings.
■ HDMI Control
Enables/disables HDMI Control (p.141).
Settings
• To use HDMI control, you need to perform the HDMI Control link setup (p.141) after connecting HDMI
Control-compatible devices.
❑ TV Audio Input
Selects an audio input jack of the unit to be used for TV audio input when “HDMI
Control” is set to “On”. The unit’s input source automatically switches to TV audio when
the TV input is switched to its built-in tuner.
Settings
AUDIO 1–4
Default
AUDIO 1
• When using ARC to input TV audio to the unit, you cannot use the input jacks selected here for connecting
an external device because the input will be used for TV audio input.
❑ ARC
Enables/disables ARC (p.26) when “HDMI Control” is set to “On”.
Settings
• You do not need to change this setting normally. In case noises are produced from the speakers connected
to the unit because TV audio signals input to the unit via ARC are not supported by the unit, set “ARC” to
“Off” and use the TV’s speakers.
❑ Standby Sync
Select whether to use HDMI control to link the standby behavior of the TV and the unit
when “HDMI Control” is set to “On”.
Settings
■ Audio Output
Selects a device to output audio.
• The “Amp” and “HDMI OUT1” settings are available only when “HDMI Control” is set to “Off”.
• The “HDMI OUT2” setting is available only when “HDMI OUT2 Assign” (p.113) is set to “Main”.
❑ Amp
Enables/disables the audio output from the speakers and headphones connected to
the unit.
Settings
Off (default) Disables HDMI Control.
On
Enables HDMI Control.
Configure the settings in “TV Audio Input”, “ARC” and “Standby
Sync”.
Off Disables ARC.
On (default) Enables ARC.
Off Does not set the unit to standby mode when the TV is turned off.
On Sets the unit to standby mode when the TV is turned off.
Auto (default)
Sets the unit to standby mode when the TV is turned off only when the
unit is receiving TV audio or HDMI signals.
Off Disables the audio output from the speakers and headphones.
On (default) Enables the audio output from the speakers and headphones.