Filter
Top Products
18
Appendix
Guide to Utility Mode Functions
The following table briefly describes the functions that can be accessed using the UTILITY key. Each
function is listed in order of appearance. The number to the right of the function’s descrption indicates the
page of this manual where you will find instructions on use of the function.
Utitlity Mode Functions
Page
9
9
14
14
14
16
16
16
17
15
15
15
Function Type Description
INT. PARAMETER Program edit Used to edit the internal parameters of the
currently selected program.
TITLE EDIT Program edit Allows editing of the title of the currently
selected program.
INPUT SELECT System setting Sets the REV500 to use either mono or stereo
input
OUTPUT MODE System setting Switches between efffect output only and
effect output plus direct source output
FOOT SWITCH System setting Selects the REV500 function that can be
controlled by a connected footswitch
MIDI CHANNEL System setting (MIDI) Sets the MIDI channel that the REV500 will
use to receive and send MIDI data
MIDI THRU System setting (MIDI) Sets whether the MIDI OUT terminal will act
as a MIDI OUT or merged MIDI THRU
MIDI PGM TABLE System setting (MIDI) Assigns REV500 programs to MIDI Program
Change numbers
MIDI BULK DUMP MIDI utility Transmits REV500 program or system setting
data to another MIDI device
DEMO TONE TRIG System setting Sets the tone and trigger mode for the
REV500’s audition function.
INI TITLE 1/2 System setting Allows editing of the first line of the initial
title message displayed at startup
INI TITLE 2/2 System setting Allows editing of the second line of the initial
title message displayed at startup