E-14
If desired, you can adjust brightness of the display.
1 Press and hold the DISPLAY button for more than 2
seconds so that “DIMMER±0” appears on the display.
2 Holding the DISPLAY button pressed, turn the VOLUME
control clockwise to increase or counterclockwise to
decrease brightness.
This adjustment can be made even though the power of this
unit is off (in the standby mode).
Control range
When the power is on: ±0 to –6 (Preset value: ±0)
When the power is off: +3 to –3 (Preset value: ±0)
ADJUSTING BRIGHTNESS OF THE DISPLAY
SETTING THE CLOCK
1 While the power is on, press the DISPLAY button to
display the time. If the power is off, you can proceed to the
next step.
2 While holding the TIME ADJ button pressed, press the
HOUR button and set the hour.
* Press the HOUR button once to advance the time by 1
hour. Press and hold to advance continuously.
* To reverse the hour, press the button instead of
the HOUR button.
3 While holding the TIME ADJ button pressed, press the
MIN button and set the minute.
* Press the MIN button once to advance the time by 1
minute. Press and hold to advance continuously.
* The hour setting will not advance even if minute is
advanced from “59” to “00”.
* To reverse the minute, press the button instead
of the MIN button.
China and Singapore models use a 24-hour display. For
General model, either a 24-hour display or a 12-hour
display [shown by “AM (PM) 12:00”] is selected
depending on the setting of the FREQUENCY STEP
switch on the rear panel, so you cannot select a desired
type freely.
In the event of a power failure or when the AC supply
lead is disconnected.
The time display will go out, however, the clock will function
for about 5 minutes without power supply. So you do not
have to reset the time if the AC power supply is resumed
within about 5 minutes.
When the AC power supply is resumed after more than 5
minutes pass without power supply, the time display will flash
on and off to indicate that the time must be reset.
DISPLAY
MEMORY
TIME ADJ
HOUR
MIN
MEMORY
TIME ADJ
1
2
3
Changes.
Change
verändert sich
Ändras
Cambia
Cambia
Verandert.
Changes.
Change
verändert sich
Ändras
Cambia
Cambia
Verandert.