Yamaha MDX-9 CD Player User Manual


 
19
ENGLISH
Part Erase
This operation lets you erase part of a track.
1 Press # PLAY/* PAUSE to play the track
containing the part you want to erase.
2 Use SEARCH ! or to locate the beginning
of the part you want to erase (point A), then press
# PLAY/* PAUSE to pause at that point.
3 Press EDIT repeatedly to display “A–B Erase?”,
then press ENTER.
Point A (from step 2) is registered and “Erase A–_” appears in
the display.
4 Use # PLAY/* PAUSE and SEARCH to
locate the end of the part you want to erase (point
B).
5 Press ENTER to register point B.
“Check” appears, then the part you specified plays
repeatedly and “Erase A–B?” appears in the display.
To adjust point B
Turn the jog dial while the “B” of “Erase A–B?” is blinking
Point B can be adjusted up to 2 second (176 steps) in either
direction.
6 Press ENTER again.
The part is erased and “Complete” appears momentarily.
To cancel before erasing the part
Press CANCEL (or & STOP).
To undo ERASE
1 Press & STOP to set this unit to stop mode.
2 Press EDIT repeatedly to display “Undo Erase”, then
press ENTER.
“Undo OK ?” appears in the display.
3 Press ENTER again to undo.
To cancel, press CANCEL (or & STOP).
To erase parts spanning more than one track
Use the COMBINE function described below to combine
the tracks into one track before performing this operation.
Note
After part erase, a new track number is automatically assigned to
the section starting after point B.
3
3,4
2
COMBINE
This function lets you combine two consecutive tracks into
one. After you combine the tracks, the total number of
tracks decreases by one and the tracks following the
combined tracks are renumbered.
1 Press & STOP to stop playback.
2 Turn the jog dial to select the second track of the
two you want to combine.
3 Press EDIT repeatedly to display “Combine ?”,
then press ENTER.
“Check” appears momentarily, then the unit plays the 4
seconds before and after the point where the tracks will be
connected. “(track number) + (track number) OK?” appears in
the display.
4 Press ENTER again.
The tracks are combined and “Complete” appears
momentarily.
To cancel before combining the tracks
Press CANCEL (or & STOP).
To undo COMBINE
1 Press & STOP to set this unit to stop mode.
2 Press EDIT repeatedly to display “UndoCombine”, then
press ENTER.
“Undo OK ?” appears in the display.
3 Press ENTER again to undo.
To cancel, press CANCEL (or & STOP).
Notes
This operation is not possible when track 1 is selected.
You can also divide the track later using the DIVIDE function.
If “Can’t Edit” appears in the display the tracks cannot be
combined. This sometimes happens when you have edited
the same track many times. This is due to the technical
limitations of the MD system and is not a mechanical error or
malfunction.
CANCEL
TIMER
OFF
PLAYREC
POWER
DISPLAY TITLE CHARA. DELETE EDIT SET
CANCEL ENTER
INPUT
REC LEVEL
SEARCH
STOP
#
*
REC
+
NATURAL SOUND MINIDISC RECORDER MDX-9
010
PLAY/
PAUSE
&
⁄!
›$
)
s
1