Yamaha MDX-9 CD Player User Manual


 
15
ENGLISH
TIME RESCUE RECORDING
The Time Rescue (TIME) recording function allows you to
start recording four seconds before you press record.
During record pause mode, the MD recorder monitors the
input signal and continuously maintains a four second
memory “cache”. Therefore, you can record a song that
just started without cutting off the beginning. You may find
this function useful when recording live broadcasts, or
when you want to start recording from the beginning of a
song without recording lots commercials (etc.).
1 Press INPUT repeatedly to select the input
connected to the sound source you want to
record.
2 Locate the point where you want to start
recording.
3 Press REC to set this unit to record pause mode.
The REC * indicators light up.
“REC Standby” and the amount of time available for recording
flash alternately in the display.
If you selected ANALOG in step 1, adjust the recording level
as described in “Recording Level”.
4 Press TIME to start recording when you hear the
beginning of a song you want to record.
Recording starts from the memory cache, allowing you to
record from a point approximately four seconds before you
pressed TIME.
Note
To take full advantage of the Time Rescue Recording function,
be sure to wait at least four seconds between steps 3 and 4.
CHAR.TITLE SETDELETENUMBER
SEARCH
!
INPUT
SKIP
$
PAUSE
*
PLAY
REC
?
STOP
&
s
MDX
CD-P
REC
SYNCTIME
M-MARK MONO/ST
1
3
4
SYNCHRO RECORDING
The synchronized recording function lets you set this unit
to start recording automatically when a sound signal is
input. When operating this unit in combination with a
remote controllable Yamaha CD player, you can use the
CD-PLAY button on this unit’s remote control to start
playback from the CD player.
1 Load the sound source into the source
component.
If necessary, program, or select the track you want to
start recording from before proceeding to the next
step. (Refer to the operation manual supplied with your
source component for instructions regarding its use.)
2 Press INPUT repeatedly to select the input
connected to the sound source you want to
record.
3 Locate the point where you want to start
recording.
4 Press SYNC to set this unit to record pause
mode.
The REC * indicators light up.
“Synchro REC” and the amount of time available for recording
flash alternately in the display.
If you selected ANALOG in step 2, adjust the recording level
as described in “Recording Level”.
5 Start playing the sound source. (Press CD-P if
recording from a Yamaha CD player.)
The MD starts recording automatically when a sound signal is
input. When the sound signal stops, the unit switches back to
record pause mode and “Synchro REC” blinks in the display.
6 To continue recording, repeat step 5.
When you have finished recording, press & STOP
on this unit to cancel the record pause mode.
CHAR.TITLE SETDELETENUMBER
SEARCH
!
INPUT
SKIP
$
PAUSE
*
PLAY
REC
?
STOP
&
s
MDX
CD-P
REC
SYNCTIME
M-MARK MONO/ST
5
2
4